EEWORLDEEWORLDEEWORLD

Part Number

Search

HEP70-S200360

Description
harmonic correction (pfc) AC/DC external desktop adapter universal input single output 68 watts switching power supplies
File Size257KB,2 Pages
ManufacturerHitron
Websitehttp://www.hitron-e.com/
Download Datasheet Compare View All

HEP70-S200360 Overview

harmonic correction (pfc) AC/DC external desktop adapter universal input single output 68 watts switching power supplies

H HiTRON
HARMONIC CORRECTION (PFC) AC/DC EXTERNAL DESKTOP
ADAPTER UNIVERSAL INPUT SINGLE OUTPUT 68 WATTS
SWITCHING POWER SUPPLIES HEP70 SERIES
FEATURES:
ACCOMMODATE UNIVERSAL AC INPUT
DESKTOP IEC320-3PL/2P AC RECEPTACLE
MEET IEC61000-3-2 HARMONIC
CORRECTION
MEET UNIVERSAL SAFETY STANDARDS
EMI MEET EN 55022/FCC CLASS B
CE MARKING COMPLIANCE
SPECIFICATION
INPUT SPECIFICATION
Input Voltage:
90-264Vac typical.
Power Factor Correction (PFC) installed.
Input Connector:
IEC320-3PL or 2P AC receptacle.
Input Frequency:
47-63Hz.
Inrush Current:
60A@230Vac.
Input Current:
0.7A@115Vac & 0.37A@230Vac typical.
Dielectric Withstand:
Meet IEC60950-1.
EMI:
Meet EN55022 / FCC Class B.
Power Factor Correction:
Meet IEC61000-3-2 Harmonic
Correction. PF typ. 0.95-0.99.
Hold-up Time:
16mS @115Vac typical.
38.4mS @230Vac typical.
Over Temp. Protection (OTP):
Installed.
Earth Leakage:
0.34mA @230Vac.
OUTPUT SPECIFICATION
Output Voltage:
See Ratings Chart.
Output Current:
See Ratings Chart.
Output Wattage:
68 Watt typical.
Connector & Cord:
Optional.
Line Regulation:
0.1% typical.
Load Regulation:
±3.0% typical.
Noise & Ripple:
1.0% typical peak to peak.
OVP:
Built-in. (Latch).
Adjustability:
Factory set.
Overload Protection:
Fully protected against output overload and short circuit.
OLP typically set at 116% max. load.
Consult the factory for special OLP setting.
Operating Temperature:
0 to +25/35/40°C
without derating. (various with output voltage)
Storage Temperature:
-20°C to +85°C.
Temperature Coefficient:
0.04%/°C typical.
Cooling:
Free air convection cooling.
Construction:
Impact resistant thermo- plastic enclosure.
Desktop Format.
GENERAL SPECIFICATION
Efficiency:
87.0% typical.
Switching Frequency:
Approximate 65K-73K Hz.
Circuit Topology:
Fixed frequency Flyback circuit.
Transient Response:
Output voltage returns in about
0.4mS following a 50% load change.
Safety Standard:
Meet UL60950-1/EN60950-1 DT7
for Class I DT8 for Class II.
Power Density:
5.83 Watts / Cubic inch.
NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified.
(2) Load regulation is measured at 115Vac or 230Vac in percentage to indicate the change in output voltage as the load is varied from half load to full load (±%).
(3) The typical cord length is about 1 meter (3.3 ft.), AWG#18 cord for various load conditions.
(4) Due to requests in market and advances in technology, specifications subject to change without notice.
In application
-37-

HEP70-S200360 Related Products

HEP70-S200360 HEP70-S200360-8
Description harmonic correction (pfc) AC/DC external desktop adapter universal input single output 68 watts switching power supplies harmonic correction (pfc) AC/DC external desktop adapter universal input single output 68 watts switching power supplies
MCU stc isp cannot be opened
As the title says. After I install the isp or run it with the green version, it prompts that a file is missing, but I have this file in my folder and I downloaded a new one online and decompressed it ...
ljpronaldo Embedded System
This is what the exam is like. I didn't submit it the first two times? What's going on?
After taking the last pilot test, I checked the details and it turned out to be like this. Is there something wrong with the system? I am worried that I will not receive the board, and I was not given...
yirenonege Microcontroller MCU
Problems in state transition program in Verilog FPGA
module contral(clk1hz,rst_n,hold,led,num,flash); input clk1hz; input rst_n; input hold; //incident happen //input INTI; //traffic light initial state output [2:0] led; //traffic light output [4:0] num...
eeleader-mcu FPGA/CPLD
How to choose the value of the current limiting resistor to make the transistor enter a deep saturation state
Taking the common emitter circuit as an example, entering the deep saturation state is related to the base and collector resistances, the current amplification factor of the transistor and the power s...
安_然 Analog electronics
Resource Limitations
The Linux kernel has resource limits on processes, which clearly stipulates the upper limit of kernel resources that a process can consume. These limits are mandatory, and the kernel will not allow th...
chenbingjy Linux and Android
Did you know that taxi fares have increased?
Starting from April 1, the starting fare for taxis in Xi'an will be raised to 9 yuan per 3 kilometers....
yichun417 Talking

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 465  2045  522  2139  2607  10  42  11  44  53 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号