Specifications are subject to change without notice.
littelfuse.com
Reed Sensors
Flange Mounting Sensor > 59135
59135 High Temperature Flange Mount Sensor + 57135 Actuator
Electrical Ratings
Contact Type
Switch Type
Contact Rating
Voltage
4
1
Normally
Open
1
VA/Watt - max.
Switching
2
Normally Open
High Voltage
2
10
300
265
400
0.4
0.30
1.4
0.2
10
10
0.2
-20 to +150
Change
Over
3
5
175
120
200
0.25
0.18
1.5
0.2
10
9
0.3
-40 to +150
Normally
Closed
4
5
175
120
200
0.25
0.18
1.5
0.2
10
9
0.3
-40 to +150
10
200
140
250
0.5
0.35
1.2
0.2
10
10
0.3
-40 to +150
Breakdown
4
3
Vdc - max.
Vac - max.
Vdc - min.
Adc - max.
Aac - max.
Adc - max.
Ω - max.
Ω - min.
pF - typ.
°C
Current
Switching
Carry
5
2
Resistance
Contact, Initial
Insulation
Contact
Operating
Capacitance
Temperature
Product Characteristics
Operate Time
Release Time
Shock
7
7
6
6
ms - max.
ms - max.
11ms 1⁄2 sine
50-2000 Hz
G - max.
G - max.
1.0
1.0
100
30
1.0
1.0
100
30
3.0
3.0
50
30
3.0
3.0
50
30
Vibration
Notes:
1. Contact rating - Product of the switching voltage and current should never exceed the wattage rating. Contact Littelfuse for additional load/life information.
2. When switching inductive and/or capacitive loads, the effects of transient voltages and/or currents should be considered. Refer to Application Notes AN108A and AN107 for details.
3. Breakdown Voltage - per MIL-STD-202, Method 301.
4. Electrical Load Life Expectancy - Contact Littelfuse with voltage, current values along with type of load.
5. This resistance value is for 11.81mm wire length. Resistance changes when wire lengthens.
6. Operate (including bounce)/Release Time - per EIA/NARM RS-421-A, diode suppressed coil (Coil II).
7. Shock and Vibration - per EIA/NARM RS-421-A and MIL-STD-202.
8. For custom modifications to the wire length or size, or adding a special connector, please contact Littelfuse.
Sensitivity Options (Using 57135 Actuator)
Select Option
Switch Type
Pull-In AT
Range
S
T
Pull-In AT
Range
U
Activate Distance
mm (inch)
Average
Pull-In AT
Range
V
Activate Distance
mm (inch)
Average
Activate Distance
Activate Distance
Pull-In AT
mm (inch)
mm (inch)
Range
Average
Average
1
2
3
4
Note:
Normally Open
High Voltage
Change Over
Normally Closed
12-18
--
15-20
15-20
18.5 (.729)
--
16.7 (.657)
16.7 (.657)
17-23
17-23
20-25
20-25
17.1 (.673)
17.1 (.673)
14.7 (.579)
14.7 (.579)
22-28
22-28
25-30
25-30
D
15.8 (.622)
15.8 (.622)
13.4 (.528)
13.4 (.528)
27-33
27-33
--
--
15.1 (.595)
15.1 (.595)
--
--
1. Pull-In AT Range: These AT values are the bare reed switch AT before modification.
2. The activation distance is average value on the final sensor assembly
MSP430 interrupt priority, on/off, and interrupt nestingThe priority order from high to low is:PORT2_VECTOR (1 * 2u) /* 0xFFE2 Port 2 */PORT1_VECTOR (4 * 2u) /* 0xFFE8 Port 1 */TIMERA1_VECTOR (5 * 2u)...
[align=center][/align] [size=3][color=#000][font=微軟正黑体, Arial,] In the hot summer, Texas Instruments (TI) will hold the "Audio and Haptic Vibration Technology Innovation Seminar" in Shanghai, Beijing,...
As the title says, if the PWM signal frequency is 46.875k, then the period is about 21.333usIs it feasible to use pc817 optocoupler? The maximum frequency is 80khz and the response time is 18us. How t...
Please help me: I need to use the remaining power in the switching power supply to write data to the NOR flash after the system is disconnected from the mains. The NOR flash has been erased before whe...
In order to prevent traffic accidents, when the intelligent detection device of the car detects danger ahead, it must send a warning message to the driver. The voice alarm clearly reminds the drive...[Details]
This article discusses how to use an ultra-low-power RF transceiver chip from Zarlink Semiconductor for pacemakers, neurostimulators, drug pumps, and other such implantable medical devices to achiev...[Details]
AD8302
Introduction
AD8302 is a monolithic integrated circuit for RF/IF amplitude and phase measurement from ADI. It is mainly composed of two precisely matched broadband logarithmic det...[Details]
0 Introduction
SAA7111 is a programmable video processor produced by Philips. The chip integrates A/D and decoding functions. It has phase lock, automatic clamp, automatic gain control, cl...[Details]
introduction
The fall detector is suitable for elderly people and children with poor self-care and self-protection abilities. It senses changes in the body posture of the individual wearing th...[Details]
There are many ways to attenuate signals. The most commonly used method is to divide the voltage using resistors. The common circuits are as follows:
Oscilloscope pre-stage attenuation c...[Details]
MIPS Technologies Inc. has introduced the CI10084tg, a next-generation global positioning system (GPS) RF tuner IP solution. The silicon-proven, integrated low-noise RF front end for GPS receivers...[Details]
IPTV (Internet Protocol TV or Interactive Personal TV), also known as interactive network television, is a new technology that uses broadband network infrastructure, takes home televisions or comp...[Details]
0 Introduction
GaAs photocathode is a negative electron affinity photocathode with the advantages of high quantum efficiency, concentrated energy and angle distribution of emitted electrons. T...[Details]
0Introduction
Microactuators, as driving components of microelectromechanical systems (MEMS), have been widely studied. In recent years, actuators made of hard magnetic and soft magnetic m...[Details]
1. Introduction
The current information age is an era built on the basis of the network. IP networks based on TCP/IP protocols, such as Internet, Intranet and Extranet, are developing with...[Details]
Electrochemical Principles of Blood Glucose Measurement
The electro-biochemical principle of blood glucose measurement is that when a certain voltage is applied to the blood after the enzy...[Details]
introduction
With the development of information technology, computer network technology represented by PC has developed to a higher stage, and the post-PC era with embedded intelligent de...[Details]
In recent years, with the popularization of automobiles and the construction of roads, economic exchanges between cities have become more frequent, and the areas of activities have become larger an...[Details]
1 Introduction
In order for a mobile robot to operate in an uncertain environment, it must have the functions of automatic navigation and obstacle avoidance. In the navigation system of a ...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
