Do I write a communication program on the upper layer of VXWORKS and then include the PPP protocol in the component? I did an experiment today. If you are an expert, please give me some advice. Thank
The actual registers of MSP430G2232 are completely different from the descriptions in the user manual of the series "MSP430x2xx Family User's Guide" (slau144j.pdf). There is no reference, which result
/*Signal definitioninclock: clockcontrol: controls the type of waveform generated. When it is 00,01,10,11, it generates sine wave, square wave, triangle wave and sawtooth wave respectively; i: control
I used the downloaded PB to make a NK.BIN, copied it to the CF card, and then inserted the CF card into PC104 to run, and I can enter the CE system normally. Question 1: When running the serial port t
Asking for help: What are the differences between the single-channel and dual-channel configurations of CS552? I have already adjusted the single-channel configuration, but the dual-channel configurat
First, add C:\ti\controlSUITE\device_support\f2833x\v133\DSP2833x_common\cmd\F28335.cmd. This file is the TI official configuration file for configuring the code to flash. Then refer to C:\ti\controlS