NXP NXP LPC80x Microcontroller Series Tutorial-EEWORLD Training

Chapters

Chapter 1：LPC80x Microcontroller Family: Ecosystem Introduction (12 minutes and 38 seconds)
Chapter 2：Detailed explanation of switch matrix technology of LPC80x microcontroller series (7 minutes and 39 seconds)
Chapter 3：Detailed explanation of serial communication technology of LPC80x microcontroller series (12 minutes and 55 seconds)
Chapter 4：Detailed explanation of LPC80x microcontroller series logic matching mechanism technology (12 minutes and 27 seconds)
Chapter 5：Detailed explanation of LPC80x microcontroller series touch button technology (16 minutes and 13 seconds)
Chapter 6：Detailed explanation of LPC80x microcontroller series programmable logic unit technology (10 minutes and 0 seconds)

Recommended Posts

12 ways to distinguish genuine batteries: The life of a mobile phone battery is limited, so sometimes the phone is still good, but the battery is already very worn out. At this time, it is necessary to buy a new mobile phone battery. As a mob; simonprince Power technology

About the pin multiplexing problem of CPLD: How to use Verilog HDL language to drive a pin as an input/output port? It is required to be output at one time and input at another time. How to program it? Thank you; eeleader-mcu FPGA/CPLD

[Evaluation of Anxinke Bluetooth Development Board PB-02-Kit] Development environment construction and download test: [i=s]This post was last edited by jinglixixi on 2021-11-17 16:17[/i]Since the routines of the development board are based on MDK, we need to install the Keil software. The version I chose is v5.30. Af; jinglixixi RF/Wirelessly

09.19【Weekly Discussion】This photodiode and triode are so similar, how to distinguish them?: Phototransistors are similar to ordinary transistors and also have current amplification, but their collector current is not only controlled by the base circuit and current, but also by light radiatio; longxtianya Integrated technical exchanges

A strange phenomenon of DCDC chip MP1470: The schematic is as follows The output voltage should be 5.18V. But the actual output voltage is 9.7V.The output is connected to two LDOs to convert to 3.3VIf both are not disconnected, it will not be; sfcsdc Analog electronics

Proteus perfect tutorial: Proteus combines advanced schematic layout, mixed-mode SPICE simulation, PCB design and automatic routing to achieve a complete electronic design system. This system has benefited from 15 years of con; wzwbx Analog electronics

NXP NXP LPC80x Microcontroller Series Tutorial