Training
Profile
The Nios II series soft-core processor is Altera's second-generation FPGA embedded processor with performance exceeding 200 DMIPS. The video explains the use of NIOS ii through practical projects of hello world, PIO, UART, and SDRAM.
Chapters
Chapter 1：Qsys_hello_world (Lecture 1) (18 minutes and 36 seconds)
Chapter 2：Qsys_hello_world (Lecture 2) (38 minutes and 10 seconds)
Chapter 3：Qsys_PIO IP core (Lecture 1) (31 minutes and 1 seconds)
Chapter 4：Qsys_PIO IP core (Lecture 2) (21 minutes and 25 seconds)
Chapter 5：Qsys_PIO interrupt (35 minutes and 49 seconds)
Chapter 6：Qsys_UART IP core (39 minutes and 59 seconds)
Chapter 7：Qsys_SDRAM IP core (46 minutes and 54 seconds)
You Might Like
Recommended Posts
- EEWORLD University Hall----AVR MCU Parallel Programming M16 Chip Unlock ATMEGA16_SD
- AVR MCU Parallel Programming M16 Chip Unlock ATMEGA16_SD : https://training.eeworld.com.cn/course/3795
-
tiankai001
MCU
- RS485 dual-machine communication under DOS
- There are three questions: Is there any difference between 232 serial port programming and 485 serial port programming under DOS? Can they be used interchangeably? What should I pay attention to when
-
felixty
Embedded System
- About the cross toolchain of BeagleBone
- I have installed the SDK, but I can find the path for which arm-linux-gnueabihf-gcc, but I cannot find the path for which arm-arago-linux-gnueabi-gcc. Please help me.
-
红叶枫叶
DSP and ARM Processors
- About MSP430G2231 crystal oscillator problem
- I used an oscilloscope to measure the P1.0 pin and observed the ACLK output. I found that the waveform was not a square wave, and the frequency kept changing from 8HZ to 26K. Could it be that my chip
-
zl53373306
Microcontroller MCU
- Ask for advice: DS generated interrupt driver
- Under WIN2000, I used DS to write a driver with interrupt No. 9 for an ISA card. I used SOFTICE to debug it. In INTOBJ, I saw that interrupt 39 was the interrupt service routine. I used idt 39 but cou
-
liuxing200
Embedded System
- STC12C5A60S2 32MHz crystal oscillator reset circuit problem
- STC12C5A60S2 is going to use a 32MHz active crystal oscillator. What changes are needed in the crystal oscillator circuit and reset circuit? This is the circuit I drew. The crystal is connected to XTA
-
libertyzx
51mcu
Recommended Content
Web users are watching Change
- EEWORLD University Hall----AVR MCU Parallel Programming M16 Chip Unlock ATMEGA16_SD
- RS485 dual-machine communication under DOS
- About the cross toolchain of BeagleBone
- About MSP430G2231 crystal oscillator problem
- Ask for advice: DS generated interrupt driver
- STC12C5A60S2 32MHz crystal oscillator reset circuit problem
- The latest IPHONE peripheral accessories design
- The Secret to Writing Error-Free C Programs
- Win7 system, installed 3.3, dsp5402 has problems, please help. .
- TI's Wireless Solutions Chinese Version
- Thanks to eeworld for the prize
- Is there a good MCU with a clearer architecture?
- Is LM3S9B96 easy to buy? How much is it?
- When I was learning about UART recently, I often saw PSC. What is PSC?
- Which Bluetooth microphone has a reference circuit? Post it and discuss it
- Power supply measurement and analysis
- 8.1 Review of the highlights of the week!
- Multisim 12 problem urgent urgent urgent urgent urgent urgent
- Problems with raw_queue_buffer_end_post
- What if you didn’t get the discount during Double Eleven? Act now and you will enjoy 30% off Microchip development tools!
- When will I be able to understand most of the posts in this forum?
- What RF engineers should know about LDO and DC/DC power supplies
- Looking for F28XX FLASH burning plug-in (program) that supports CCS3.1
- Realization of low-cost and low-power general-purpose inverter
- EEWORLD University - How to measure the efficiency of DC-DC converters
- Flyback power supply primary feedback sampling point sample hold
- LLC design and related calculations and resonance analysis
- C6678 multi-core boot is up and running <------ Sad, I was quite busy before the New Year
- De Cromon launches a sensor
- Embedded Technology
Popular Components
Just Take a Look
Hot Downloads
- Behavioral simulation of a barrel shifter
- Optimization Design of Ku-Band Microwave Broadband Filter
- Application of AD7224 in Programmable Output Variable Voltage
- AC220V AC power supply LED constant current source circuit
- CDMA Zero IF Calibration Principle
- The principle of variable frequency constant pressure water supply system in sprinkler pump room and its software and hardware transformation
- 74ACT258
- A low quiescent current, high stability LDO linear regulator
- Protel-99-SE-Multilayer Circuit Board Design and Production-536M-Video Version.zip
- Design of cotton moisture tester
MoreHot Articles
- Low Power Design of SoC System
- Low-power and high-speed data acquisition system based on DSP
- Research and Design of UART between TMS320VC5402 and PC
- Clock chip interface design for PowerPC and Dallas
- Design and implementation of automatic white balance adjustment system for color TV based on 7110
- Design of CAN bus intelligent node based on ADμC812
- Design of paperless recorder using C51 and plug-in FLASH memory
- EL6249C and its application in MEMS dynamic testing
- Implementation of Dial-up Internet Access Using Microcontroller
- Efficient instruction support for microcontrollers adapting to real-time multitasking
京公网安备 11010802033920号