The installation of connectors in electrical control cabinets still inevitably requires a lot of effort, because the cables and connector parts need to pass from the inside of the control cabinet to the outside of the control cabinet, and then assembled into the control cabinet, which is a considerable amount of work. complex and time-consuming. But this problem no longer exists, HARTING's rear panel mounting solves this challenge.
The measured data can be displayed by sending it to the computer serial port through the serial port on the board. Simple voltage measurement, current measurement and resistance measurement can be per
Could someone please guide me on the logic of writing this program? Especially how to connect the duty cycle after sampling the output voltage and current signals for PID control?
As the title says. I have also seen similar topics on the Internet, but it says that it is necessary to combine engineering, which I don’t quite understand. I want to switch to embedded development. P
I spent a day today studying the characteristics of the i2c bus. Because I want to use FPGA to design the timing of operating the i2c bus. The i2c bus is a commonly used serial bus. I want to operate