Introduction to the basics of oscilloscopes; oscilloscope calibration specifications and requirements; oscilloscope calibration solutions; oscilloscope automatic calibration demonstration.
[i=s]This post was last edited by paulhyde on 2014-9-15 09:00[/i] As the title says~~~~~~~~~~~~ A whole page of posts, what should others do? I strongly despise this irresponsible and selfish behavior
First, let's briefly explain switching-type AC/DC conversion. Please refer to the basic circuit on the right and the waveform below.
Here, taking Japan as an example, the input voltage is set to 100VA
[if gte mso 9]>MicrosoftInternetExplorer402DocumentNotSpecified7.8Normal01. Install IAR Embedded Workbench for ARM . This time I used the latest version downloaded from IAR official website , EWARM-EV
Recently, I am experimenting with PC communicating with a microcontroller through a serial port. The requirements are as stated at the beginning of the following code. However, during the communicatio
This is my first time using Allegro. When I applied copper to the power layer and ground layer (using negative film) on the PCB, all through-hole pins and vias on the board were directly covered, with