• Duration:11 minutes and 15 seconds
  • Date:2018/07/05
  • Uploader:老白菜
Introduction
keywords: AI AI
This course is mainly aimed at students and people from all walks of life majoring in non-intelligent science and technology. It introduces the rich and colorful "natural intelligence" in the natural world and the "intelligent computing" models and methods inspired by it, as well as various forms of "intelligent systems" and The ever-changing "intelligent frontier" covers multi-disciplinary knowledge such as biology, medicine, genetics, physics, society and intelligent technology, with the goal of improving scientific and cultural quality, expanding the horizons of subject knowledge, and enhancing the awareness of scientific and technological innovation.
Unfold ↓

You Might Like

Recommended Posts

Ten major changes in the electronic information industry over the past 20 years
Ten major changes in the electronic information industry over the past 20 years2006-06-01 Shenzhen Business DailyThe 20 years from 1986 to 2005 were 20 years of entrepreneurial development of China's
fighting Analog electronics
Help with WINCE system compatibility!
I am new to WINCE and would like to know if there are any problems with installing a program developed in C# under XP operating system into WINCE. Are there any compatibility requirements? For example
guoyaru123 Embedded System
Board burning problem
Every time the program of the board is changed, the board must be powered off, then powered on again, and the program must be burned again before it can run. This is inconvenient. Are there any improv
lzx_18570633112 DSP and ARM Processors
【Altera SoC Experience Tour】HD Camera Control Subsystem Design
1. Design platform: Software platform: Quartus 14.0 Hardware platform: Cyclone V SOC Using self-designed circuit board hardware 2. High-definition aerial camera system main function design: 1) High-sp
悠悠森林 FPGA/CPLD
X-NUCLEO-IKS01A3 driver for Arduino
Well, I participated in an event and was given a board for free, but the prerequisite was to debug and port it to an MCU, so I wrote the Arduino UNO. Then after I got it, I found that ST actually wrot
jianshan ST Sensors & Low Power Wireless Technology Forum
In this figure, what is the purpose of connecting a resistor in parallel to ground?
As shown in the figure, what are the functions of resistors R2, R3, R4, and R5 in this circuit diagram? Please give me some advice! ! !
迷途的小书童 Analog electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号