• Duration:8 minutes and 48 seconds
  • Date:2019/09/25
  • Uploader:木犯001号
Introduction
Beginners start with the development board + marquee. Although the program was successfully run, I was still confused;
in this album, starting from 0, the common hardware peripheral to the microcontroller is classified, analyzed, and physically tested.
It allows everyone to see how the microcontroller drives each piece of hardware, what the driving principle is, and what the driving conditions are.
Although it cannot make everyone proficient in hardware, it can give everyone an idea and know in which category to choose the model. As for having no clue.

Unfold ↓

You Might Like

Recommended Posts

What is the RSSI value displayed when the SensorTag is one meter away?
Can anyone who has used it tell me about it? For example, what is the RSSI value displayed on the phone? (In the Device Information page), it would be best if you could give the value displayed when t
wangfuchong Wireless Connectivity
Please help me analyze this op amp circuit
The circuit shown in the figure is powered by a single power supply. It can amplify when the input is a square wave signal of -25~+25mV, but there is no output when the input is 0~50mv (with DC compon
阿cat Analog electronics
A question about Linux startup parameters
My Linux kernel version is 2.6, and the kernel boot parameters are Linux command line: noinitrd root=/dev/mtdblock2 init=/linuxrc console=ttySAC0, which means that the third partition of mtd is used a
beyond1999 Linux and Android
Teach you how to build an IBIS model__V2.0
Teach you how to build an IBIS model__V2.0
linda_xia Analog electronics
I need a 51 data cable from serial port to USB
Are there any 51 beginners in the forum who need a serial to USB data cable? Please sign up to organize a group purchase. My desktop computer at home has a serial port and a parallel port, but the lap
DIAG Buy&Sell
I have some problems with reading and writing avr EEPROM. I don't know where the problem lies! Please give me some advice.
#include #include#define uchar unsigned char #defineuint unsigned intvoid init() {DDRA=0xff;PORTA=0xff;}void delay (uint z) {uchar x,y;for(x=z;x0;x--)for(y=110;y0;y--);}void eeprom_write(uint addr,uch
2592315 Microchip MCU

Recommended Content

Hot VideosMore

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号