I don't know what happened these two days. When I was using the DDR2 IP core, the problem shown in the figure below appeared. It was the warning in the figure, which caused the IP core to fail to be e
[i=s] This post was last edited by dontium on 2015-1-23 11:11 [/i] INA219 voltage drop monitoring: Refer to Figure 13 on page 9 of the data sheet. Connect a very small resistor to the high end of the
[font=宋体] [/font] [font=宋体][b][转][/b][/font] [font=宋体]When designing a high-performance data acquisition system, diligent engineers carefully selected a high-precision[/font][font=Times New Roman][col
I made a work, and I want to achieve: 1: mobile phone sends power-on command to uart0-》turn on Ta0---run 2: mobile phone sends power-on command to uart0-》turn off msp430 Ta interrupts about 10ms, oper
I recently used the DK5438 development board to adjust the UDP protocol. I would like to ask, how should the UDP protocol be simulated? Should I use the network debugging assistant or other software?
Radio Production DIY Manual. [Compiled by Zhang Ge] [China Water Resources and Hydropower Press] [2004] [470 pages] [b]Introduction[/b]: [url=http://image-3.verycd.com/48eb54154641cf4b5bca43e68e6ef1da