• Duration:19 minutes and 33 seconds
  • Date:2025/11/24
  • Uploader:hi5
Introduction
The wave of humanoid robots has arrived, and behind their dexterous movements and intelligent interactions lies the precise collaboration of numerous core components and cutting-edge technologies. In this online seminar, we have invited Beineng and its ecosystem partners—Infineon, GigaDevice, Yutai Microelectronics, Celzo, and Yushun Technology—to unveil the "technological core" of humanoid robots. We will delve into key dimensions such as the robot's "brain" (MCU), "nerves" (Ethernet), "joints" (motor drives and encoders), and "skin" (electronic skin), exploring how cutting-edge technologies like GD32 MCUs, GaN power devices, high-precision inductive/magnetic encoders, analog chips, dexterous hand solutions, and high-efficiency motor drives shape the performance boundaries of next-generation robots.
Unfold ↓

You Might Like

Recommended Posts

Help. I want to build a system for "elderly fall detection"
But I am a rookie, and this is a topic I changed temporarily for my graduation project. I hope that those who know the relevant information can give me help, I will be very grateful. Those who know ca
守着阳光 RF/Wirelessly
TMP006 Temperature Measurement
How to use RS232 serial port to transmit the temperature collected by TMP006 to PC?
Challenge007 Microcontroller MCU
IP set-top box software system structure design and development.pdf
Software system structure design and development of IP set-top box.pdf
yuandayuan6999 MCU
Output MSP430FR5969
[i=s]This post was last edited by lonerzf on 2015-1-23 22:08[/i] As the title says, after participating in the Wolverine event, this board has no occasion to be used for the time being, so I am sellin
lonerzf Buy&Sell
OSEK VDX
OSEK is the most commonly used automotive ECU operating system.
5525 Automotive Electronics
What kind of switch tube can be used to replace this switching power supply circuit?
The schematic diagram is as follows. I drew it based on the real thing. The output is to light up the halogen lamp on the CNC lathe, about 30W, that is, the output is about 12V/3A. The two switch tube
huang0909 Power technology

Recommended Content

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
community

Robot
development
community

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号