elleny

u-blox Wi-Fi^® Evaluation Kits: EVK-LILY-W131 & EVK-LILY-W132

Easy access to SDIO and USB interface for quick evaluation

Overview

Based on 88W8801, NXP's 2.4 GHz Single-Band 1x1 Wi-Fi 4 (802.11n) solution, this evaluation board comes with a SDIO card connector and a micro USB connector, selectable voltage level for power supply and GPIOs, as well as two antenna options. The LILY-W132 provides an integrated antenna, while the LILY-W131 evaluation board connects to an external antenna via U.FL.

MoreCollapse

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-05-13 10:56:48

About the delay of DM9000A
I recently used a DM9000A network card under WinCE. Now I found that when the host pings the development board, there will be a high delay of 1 frame (seconds) after pinging a few frames, and the rest
Intelligent monitoring robot
[i=s]This post was last edited by paulhyde on 2014-9-15 09:29[/i] Intelligent Monitoring Robot
NeoPixel NanoRing
使用 [url=https://www.adafruit.com/product/3501]Adafruit Gemma M0[/url] 和 [url=https://www.adafruit.com/product/3484]Nano RGB LEDs[/url] 制作的指环[img=600,338]https://cdn-blog.adafruit.com/uploads/2019/01/a
Tasks cannot be switched when porting ucos to lpc2292
Can anyone help me? I have ported ucos to lpc2292 and created two tasks in the project. During the simulation, I found that the two tasks stopped switching after running once, but stayed in the idle t
How to optimize the area of FPGA design
1. When the speed requirement is not very high, we can design the pipeline in an iterative form to reuse the resources with the same FPGA function.2. When the control logic is smaller than the shared
Has anyone ever calculated the modulus after doing an FFT?
I call an IP core to perform FFT calculation in FPGA, and want to take the modulus of the data. I don't know how to do it. Does anyone know how to do it? Please advise! {:1_94:}{:1_94:}

Datasheet More

Circuits More

u-blox Wi-Fi® Evaluation Kits: EVK-LILY-W131 & EVK-LILY-W132

Easy access to SDIO and USB interface for quick evaluation

u-blox Wi-Fi^® Evaluation Kits: EVK-LILY-W131 & EVK-LILY-W132