aerobotics

Elrs_Rx_1.1

Overview

The sample has been tested and put on the machine. It is recommended to solder the esp8266 side first, then burn the code, and then solder the sx1280 module.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2025-06-20 15:36:52

Help
Does anyone know how to sense a circuit 10 meters or more away? (That is, how to sense the voltage returned by the object or person in front of it) Can anyone tell me? I hope we can communicate with e
Data collision processing of RF multi-point communication of cc2530
I'm learning CC2530F256 recently. Now I'm debugging RF communication (simple RF communication, no protocol stack). Considering that there will be data collision during multi-point communication, how t
Please advise!!! About the peak detection circuit!!!
Now there is a sinusoidal voltage with a peak-to-peak value of 1 to 1.5V. Can the peak value be detected using the following diagram? If not, is there any better method? Thank you very much! ! ! In ad
A relatively novel approach to achieve
I recently found a clever part when I was looking at the code. When you usually use 12864 or 1602 to display numbers, I believe everyone will first split it up, convert it into the corresponding ASCII
[My entry into electronic technology] ----My entry into electronic technology
[font=新宋体] [size=3]I first came into contact with electronics when I was a sophomore. At that time, a teacher in our college began to organize us to learn welding technology. At that time, we welded r
Please ignore the points
Just for points

Datasheet More

Circuits More