Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
Please help me figure out why the program cannot run if jtagWait() is written in, but can run if jtagWait() is deleted. I will give a very simple example./********************************main*********...
I drew an FPGA application board, Altera, TQFP144 package. I used a simple frequency division program, and Quartus showed that the program download was completed, but the output was all high. I need g...
1. Origin of the Project In recent years, fire accidents with mass deaths and injuries have occurred from time to time, such as the Yiyuan Song and Dance Hall in Fuxin City, Liaoning, the Friendship H...
[font=微软雅黑][size=3]
[url=http://www.ti.com.cn/tool/cn/TIDA-00056]>>Gas Sensor Platform with Bluetooth Low Energy[/url][url=http://www.ti.com.cn/tool/cn/TIDA-00010]>>Pulse Oximeter via Finger Clip Refe...
1 When powered on separately, I tested the levels of each JTAG pin. TMS TDI and so on are all high, but TDO is low, only about 0.2V. Is this normal? Does JTAG affect the work of DSP? 2 The reset pin o...
Need a low current charging IC and a Bluetooth chip with integrated MCUBattery specification: Lithium battery, platform voltage 3.7V, full charge 4.2V
The required charging IC requirements are as foll...
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
