Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[i=s]This post was last edited by WZH70246 on 2017-3-1 21:46[/i]Official source code and development document URL: [url=http://www.st.com/content/st_com/en/products/evaluation-tools/solution-evaluatio...
WZH70246ST Sensors & Low Power Wireless Technology Forum
There is a question that requires this: use a button to control the digital tube count. Each time the button is pressed, 1 is added, from 00 to 99. After reaching 99, the button returns to 00, and the...
The first time I downloaded the program to the 2812 FLASH, it was successful and the program could be executed. After erasing the next day, the download failed and reported:Flash API Error #31:There w...
[b]Honestly recruiting R&D engineers[/b] Our company produces medical electronic related equipment and cooperates with universities for R&D. We are now recruiting 1-2 R&D engineers. The main job is to...
I used LM393, but I used a board made with this principle. There was no problem with the output signal of a previous board, but the output voltage of LM393 on this board is 0V, 1.25V, and 5V. It only ...
The 1602 and 12864 programs on the 2553 can run normally, but when transplanted to the 5529, there is no display. The wiring is fine and the oscilloscope test circuit has signals. I don't know why, ho...
ST Sensors & Low Power Wireless Technology Forum
京公网安备 11010802033920号
EEWORLD
