Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
I didn't find any information about temperature in the STEVAL-IDB007V1_datasheet, so I only chose the lowest temperature I could reach (put it in a household refrigerator). My evaluation is different ...
I have been working on this project for two weeks, but I don't know how to put it together, and I can't receive any data. I hope someone can help me....
[i=s]This post was last edited by dontium on 2015-1-23 11:12[/i] This document introduces the solution launched by Texas Instruments. For more information, please click the link to visit the Texas Ins...
Recently, the project involves cooperation with suppliers. I can no longer use atmel studio. I have to switch to keil. So I dived for a while, calmed down and carefully analyzed the datasheet. Finally...
RF PA (Power Amplifier) chips consume a lot of power and have high reliability requirements. They are an important part of wireless communication systems. As the frequency and power of 5G systems are ...
ST - Low Power RF
京公网安备 11010802033920号
EEWORLD
