How to measure the current of the primary of the switching power supply transformer with an oscilloscope? I only have an analog oscilloscope.
Is it only possible to use a digital oscilloscope to obser...
[i=s]This post was last edited by DDZZ669 on 2020-9-18 22:05[/i]The previous article " 【GD32450I-EVAL】+ 02 Software Development Environment Configuration (KEIL 5) and Running Light Test " introduced t...
I downloaded the STM8 library these two days and followed some instructions to add what should be added. There is an interrupt. I remember it is STM8-interrupt-vector.c. It is always automatically add...
[i=s]This post was last edited by littleshrimp on 2015-12-9 11:46[/i] Should the ADC driver in the figure be placed closer to the signal input terminal on the left or closer to the ADC on the right? I...
In the past week, I used the EP1C3T144C8 FPGA to embed NIOS2 and studied the drivers of FLASH and SDRAM. Finally, it was easy to use, but I encountered many twists and turns in the process. Now I will...
1. Introduction
Since the 1980s, with the continuous development of automotive electronic technology, there are more and more electronic control units in automobiles, such as electronic fuel i...[Details]
0. Introduction
In daily life, we often see some special-purpose vehicles. When these vehicles pass through intersections, they often obtain the right of way at intersections by temporarily op...[Details]
At very low temperatures, certain metals and alloys lose their resistance to electric
current
and become
superconductors
. Two parameters that are often measured are the transition ...[Details]
0 Introduction
There are many types of sensors, and the working principles, measurement targets and measurement environments of different types of sensors vary greatly. The corresponding detection s...[Details]
introduction
At present, the research on micron and nanotechnology is very active, which has led to the rapid development of microtechnology and micro-mechanical electronic system (MEMS) t...[Details]
The demand for improved healthcare environments is endless, so medical imaging equipment with higher resolution is needed to better observe the human body. High resolution brings problems with sign...[Details]
Every time I go home and walk up the stairs, I am always scared. The corridor lights are often broken, and no one changes the bulbs, or they are not smart enough and need to be operated manually. E...[Details]
LED is now known as the fourth generation of light sources. High-power LED has many advantages over traditional light sources in outdoor lighting.
1 LED lamps have high light efficiency
C...[Details]
Battery clamps, commonly known as battery connectors, come in two sizes depending on the thickness of the battery terminals. One is the battery clamp used on thick terminals, with a positive termin...[Details]
Electrostatic coupling and interference occur when a charged object is close to the input of the circuit being measured. At low impedance, the effects of interference are not noticeable because th...[Details]
The capacity of a battery depends on the amount of charge and discharge, in addition to some factors of the battery itself. Obviously, if the charge and discharge of the battery can be recorded all...[Details]
This article focuses on closing the feedback loop of an isolated power supply using a TL431 shunt regulator. The article discusses a method to extend the bandwidth of the power supply control loop ...[Details]
As a new type of centralized and decentralized elevator control system, serial communication has been widely used in China. Compared with the previous centralized and unified control system, each s...[Details]
Reliability and real-time performance are the basic requirements for control systems. Initially, motor control used analog circuits with discrete components. With the advancement of electronic tech...[Details]
1. Introduction
With the continuous development of modern urban construction, infrastructure and real estate are becoming increasingly prosperous, and the quality requirements for construction ...[Details]