1M1-SP3-R5/2-1M5-3QE

Since the No. 4 blast furnace of Handan Iron and Steel was put into operation in 1993, its external equipment has been seriously aged, and the original PLC control system TDC3000 of the hot blast furn...[Details]

Problems such as the depletion of natural resources, air pollution, traffic congestion, and rising fossil fuel prices have forced societies and individuals to seek alternative means of transportati...[Details]

Motors, especially those with brushes, generate a lot of noise. This noise must be dealt with if the appliance is to meet the requirements of EMC standards. The means to solve EMC are nothing more ...[Details]

System Overview The system consists of a signal preprocessing circuit, a single-chip computer AT89C2051, a systematic LED display module, a serial port data storage circuit and system software...[Details]

1. Proposal of reconfigurable measurement and control system The measurement and control system generally refers to a system based on computers to realize data acquisition a...[Details]

A stepper motor is an electromagnetic mechanical device that converts an electrical pulse signal into an angular displacement or a linear displacement. The stability and reliability of a stepper mo...[Details]

LED is the abbreviation of the English word. Its main meanings are: LED = Light Emitting Diode, a solid-state semiconductor device that can convert electrical energy into visible light. It can dire...[Details]

One in five car failures are caused by batteries, a problem that will become more serious in the coming years as electric-by-wire, start/stop engine management and hybrid (electric/gas) vehicles be...[Details]

DCDC means DC to DC (conversion of different DC power values). Anything that meets this definition can be called a DCDC converter. Specifically, it means converting the input DC into AC through a s...[Details]

The power consumption of a switching power supply includes fixed losses caused by parasitic resistances such as semiconductor switches, magnetic components, and wiring, as well as switching losses ...[Details]

This paper describes the design method of electronic multifunctional watt-hour meter, the key technology of hardware design and the software design process. Taking NEC's μPD78F0338 microcontroller ...[Details]

Preface DS18B2 is generally used in conjunction with a single-chip microcomputer, and there are few reports on the interface between DSP and DS18B20. Therefore, this article introdu...[Details]

introduction Frequency characteristic tester Also known as sweep frequency meter or frequency response analyzer, it uses a rectangular oscilloscope with internal scale as a displ...[Details]

0 Introduction In the design and construction of communication systems, communication power supply is called the heart of the communication system. The power supply system will dire...[Details]

The embedded network module series products of Yingchuang Company all have a streamlined ISA expansion bus, which usually includes several address buses, 8-bit data buses, read and write control li...[Details]