352413-1

Function List and Notes (lower-level driver part) 1. IO port initialization: control IO and communication IO. Control includes power control, reset and low power mode. Communication is the serial po...[Details]

After studying the F4 FSMC method to drive the touch screen for a few days, I have gained some understanding, which are listed below. The unorganized record is only for my own reference in the future...[Details]

Artificial intelligence There is no inherent bias in AI. It does not "think" something is true or false for reasons that cannot be explained by logic. Unfortunately, human bias exists in mach...[Details]

    This paper proposes a design scheme for an embedded CNC system based on ARM and FPGA. The software and hardware design of the ARM system, the implementation method of hardware fine interpolation ...[Details]

    The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]

pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t  AD_Channel)   {          hadc.Instance- CHSELR = 0;       ADC_ChannelConfTypeDef sConfig;       sConfig.Channel = AD_Channel;           sConf...[Details]

Pin Definition  FSMC configuration steps 1. Enable the corresponding pin GPIO clock  2. Configure the GPIO pin mode  3. Enable the FSMC clock  4. FSMC initialization  5. Memory block enable Examp...[Details]

Today I am using the AD function of the stm8s microcontroller. There are ten channels from AN0 to AN9 on the microcontroller. I want to use only three of them, AN5 to AN7. //ADC initialization void A...[Details]

Proteus simulation circuit diagram C language program #include  absacc.h    #include  reg52.h       #define DA0832 XBYTE       #define uchar unsigned char   #define uint unsigned int     ...[Details]

Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]

Please help me analyze the clock cycles occupied by the following delay program. Seek to explain: DELAY:  MOV  R6, #13 DELAY1: MOV  R5, #250 DELAY2: NOP         DJNZ  R5, DELAY2         DJNZ  R6, DEL...[Details]

Requirements: Set timer T1 as an external event counter, count 500 pulses every time, then switch T1 to timing mode and output a positive pulse with a width of 10ms at P1.2. Over and over again. A...[Details]

//******************************************************************************/ #include msp430.h //Note: There must be a delay between two transmissions, otherwise it cannot be sent again, seria...[Details]

1. SCL is always controlled by the Master. SDA is controlled by the Slave when reading data and by the Master when writing data according to the direction of data transmission. After the 8-bit data i...[Details]

　　According to a report by Russian News Agency on November 23, Alexander Hanin, founder and general manager of VisionLabs, a Russian facial recognition software development company, believes that in ...[Details]