Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
Previous post: Two problems with MAPLAB - [PIC Microcontroller] - Electronic Engineering World Forum Other people's development environments could configure clocks and pins, but mine couldn't. Today I...
The DS1667 contains two integrated circuit potentiometers, which can be adjusted by selecting resistor elements by counting. Each potentiometer consists of 256 resistor elements, and each resistor seg...
I want to customize a touch screen and a switch that can be controlled by wifi. WIFI is connected to the mobile phone just like the Xiaomi box WIFI connection method. The purpose is to control the swi...
Low power consumption product design. Currently, the current meter is connected in series for segmented measurement. Long-term 2uA. Short-term 4.5mA. Instantaneous 20mA. Is there any good way to use a...
I use MSP430 G2231, and CCS5.1 is installed in my computer, but why can't I install the driver after connecting the launchpad to the computer's USB? Can anyone help me? Thank you so much... I tried to...