1. Contact rating - Product of the switching voltage and current should never exceed the wattage rating. Contact Littelfuse for additional load/life information.
2. When switching inductive and/or capacitive loads, the effects of transient voltages and/or currents should be considered. Refer to Application Notes AN108A and AN107 for details.
3. Breakdown Voltage - per MIL-STD-202, Method 301.
4. Electrical Load Life Expectancy - Contact Littelfuse with voltage, current values along with type of load.
5. This resistance value is for 11.81mm wire length. Resistance changes when wire lengthens.
6. Operate (including bounce)/Release Time - per EIA/NARM RS-421-A, diode suppressed coil (Coil II).
7. Shock and Vibration - per EIA/NARM RS-421-A and MIL-STD-202.
8. For custom modifications to the wire length or size, or adding a special connector, please contact Littelfuse.
Sensitivity Options (Using 57020 Actuator)
Select Option
Switch Type
Pull-In AT Range
S
Activate Distance – D
mm (inch)
Average
1
Note:
Normally Open
6-10
6.0 (.236)
1. Pull-In AT Range: These AT values are the bare reed switch AT before modification.
2. The activation distance is average value on the final sensor assembly.
RFID is also known as electronic tag, long-distance radio frequency card, long-distance IC card, radio frequency tag, transponder, data carrier; RFID reader is also known as electronic tag reader, lon...
Infrared remote control is a wireless, non-contact control technology. It has significant advantages such as strong anti-interference ability, reliable information transmission, low power consumption,...
[size=3] Today, when evaluating a power supply demo board, I encountered a small problem. I couldn't use an oscilloscope to measure the primary side of the transformer. When the power supply board was...