(Above which the useful life may be impaired. For user guidelines, not tested.)
Storage Temperature .......................................................... –65°C to +150°C
Note:
Stresses greater than those listed under MAXIMUM
Ambient Temperature with Power Applied ............................. –40°C to +85°C RATINGS may cause permanent damage to the device.
Supply Voltage to Ground Potential (Inputs & Vcc Only) ........ –0.5V to +4.6V This is a stress rating only and functional operation
Supply Voltage to Ground Potential (Outputs & D/O Only) ..... –0.5V to +4.6V of the device at these or any other conditions above
those indicated in the operational sections of this
DC Input Voltage .................................................................... –0.5V to +5.5V specification is not implied. Exposure to absolute maxi-
DC Output Current ..............................................................................120mA mum rating conditions for extended periods may affect
Power Dissipation .................................................................................. 0.5W reliability.
DC Electrical Characteristics
(Over Operating Range, T
A
= –40°C to +85°C, V
CC
= 3.3V ±10%)
Parameters Description
V
IH
V
IL
I
IH
I
IL
I
OZH
V
IK
R
ON
Input HIGH Voltage
Input LOW Voltage
Input HIGH Current
Input LOW Current
Clamp Diode Voltage
Switch On Resistance
(4)
Test Conditions
(1)
Guaranteed Logic HIGH Level
Guaranteed Logic LOW Level
V
CC
= Max., V
IN
= V
CC
V
CC
= Max., V
IN
= GND
V
CC
= Min., I
IN
= –18mA
V
CC
= Min., V
IN
= 0.0V, I
ON
= 48mA
V
CC
= Min., V
IN
= 2.4V, I
ON
= 15mA
Min.
2.0
–0.5
Typ
(2)
Max.
0.8
±1
±1
±1
Units
V
µA
V
Ω
High Impedance Output Current 0
≤
A, B
≤
V
CC
–0.73
5
8
– 1.2
7
15
Capacitance
(T
A
= 25°C, f = 1 MHz)
Parameters
(5)
C
IN
C
OFF
C
ON
Description
Input Capacitance
A/B Capacitance, Switch Off
A/B Capacitance, Switch On
Test Conditions
V
IN
= 0V
V
IN
= 0V
V
IN
= 0V
Typ
3.5
5.0
10.0
Units
pF
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V
CC
= 3.3V, T
A
= 25°C ambient and maximum loading.
3. Not more than one output should be shorted at one time. Duration of the test should not exceed one second.
4. Measured by the voltage drop between A and B pin at indicated current through the switch. ON resistance is determined
by the lower of the voltages on the two (A,B) pins.
5. This parameter is determined by device characterization but is not production tested.
京公网安备 11010802033920号
EEWORLD
