User I/O: No explanation required. Configuration pins: MSEL[1:0] Used to select configuration mode, such as AS, PS, etc. DATA0 FPGA serial data input, connected to the serial data output pin of the co...
This is my DS1302. Can anyone help me try it? SCLK=P1^0, IO=P1^1, REST=P1^2; the digital tube segment is P3 port, the bit is P2^0-P2^3, but I show 1100. I don't know what's going on. Please help me ch...
I am using the audio driver in the BSP that comes with LPC3250. When I call DeviceIoControl in the application to open the audio device, an error occurs during compilation, saying that IOCTL_WAV_MESSA...
I just bought a development board and want to write a program to light up an LED. The s3c2410 board has two LEDs connected to GPF4 and GPF7. I want to light up these two LEDs, but I can't write a prog...
As a single-host multi-slave bus system, the number of slave devices that can be connected to a 1-Wire bus is almost unlimited. In order to avoid logical conflicts, the 1-Wire bus interfaces of all...[Details]
As the whole equipment is becoming increasingly miniaturized and power-saving, low-dropout linear regulators (LDOs) with low power consumption are becoming the mainstream in the market for linear regu...[Details]
0 Introduction
At present, the analysis of intra-pulse signals in pulse radar has always been a hot topic and difficulty in research. How to measure the intra-pulse carrier frequency more ...[Details]
Complex circuits and 3D EM simulation tools have reached a point where complex system-level behavior can be simulated before fabrication. Performing EM simulations simultaneously with circuit simul...[Details]
introduction
Controller Area Network (CAN) is a bus standard proposed by Bosch of Germany to solve the information communication between automotive electronic control units. With its excel...[Details]
Among the many candidate standards for China's mobile TV, the CMMB standard proposed by the Broadcasting Science Research Institute of the State Administration of Radio, Film and Television is aime...[Details]
With the continuous emergence of new technologies and the increasing complexity of DSP real-time systems, there are more and more different types of external devices. Writing drivers for these exte...[Details]
Abstract: By controlling the supply voltage of the radio frequency (RF) power amplifier (PA) in a CDMA/WCDMA cellular phone, the PA efficiency can be improved, heat generation can be reduced, and t...[Details]
Preface
In the application of PLL, DLL and CDR circuits, people generally require the output clock signal to have a 50% duty cycle so that data can be sampled at both the rising and fallin...[Details]
1 Introduction
Many test systems require real-time data acquisition while continuously moving. If the test process is discontinuous, or the test position is in front and the acquisition is...[Details]
PSoC is a programmable system-on-chip produced by Cypress Semiconductor with an 8-bit MCU core and a digital and analog mixed signal array. PSoC integrates three programmable capabilities into one....[Details]
After being widely adopted in applications such as backlighting of portable products with small and medium-sized screens, light-emitting diodes (LEDs) have entered the field of general lighting in ...[Details]
Prisons are an important part of the national judicial organs, shouldering the important mission of enforcing laws and disciplines and educating and reforming. The safety of prisons is related to t...[Details]
0 Introduction
μClinux is an operating system for embedded control. It inherits most of the features of the Linux kernel and is designed for embedded microprocessors without a memory manag...[Details]
In electronically controlled gasoline injection engines, the oxygen sensor used for closed-loop control of the fuel system is an important electronic component that monitors the oxygen content in t...[Details]