Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[url=https://download.eeworld.com.cn/detail/wu2223317/561087]Charger schematic diagram[/url] [url=https://download.eeworld.com.cn/detail/laomaoshu/561090]Calculation of the optimal inclination angle o...
Whether digital or analog, data must be converted into signals for the purpose of transmission. The process of converting data into analog signals is called modulation, and the process of converting d...
[i=s]This post was last edited by paulhyde on 2014-9-15 09:21[/i] China Ocean University 2009 Undergraduate Electronic Design Competition Selection Questions...
Help, we are working on a project, using STM32F103C8T6, SIM800C 2G network, RC522 on the motherboard for radio frequency identification, currently 120 have been produced, more than 70 have been put in...
I've been looking at open source projects like pandaboard ES and beagleboard xM / beaglebone these days and I'm looking to start a group. The boards all look good....
Power technology
京公网安备 11010802033920号
EEWORLD
