Resistance to sulphur-bearing gas (AS version only): ASTM-B-809
Voltage proof
Volts
Note: A 0.01 Ohm addition to be added to the performance of all resistors <10 Ohms.
ΔR%
ΔR%
ΔR%
ΔR%
ΔR%
1
1
1
0.25
0.25
0.25
500
ΔR%
ΔR%
Maximum
1
0.1
Zero at 155°C
0.1
0.2
0.25
0.05
0.05
0.05
Typical
0.25
0.02
Pulse Performance Data
Pulse Performance Data
Lightning Surge
Lightning surge resistors are tested in accordance with IEC 60 115-1 using both 1.2/50µs and 10/700µs pulse shapes. 10 pulses are applied. The limit of
acceptance is a shift in resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Lightning Surge
Lightning surge resistors are tested in
accordance with IEC 60 115-1 using
both 1.2/50µs and 10/700µs pulse shapes.
10 pulses are applied. The limit of
acceptance is a shift in resistance of less
than 1% from the initial value.
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
The single impulse graph is the result of 50 impulses of rectangular shape applied at one minute intervals. The limit of acceptance was a shift in
resistance of less than 1% from the initial value.
2512
2010
1206
0805
0603
Continuous Load Due to Repetitive Pulses
The continuous load graph was obtained by applying repetitive rectangular pulses where the pulse period was adjusted so that the average
power dissipated in the resistor was equal to its rated power at 70°C. Again the limit of acceptance was a shift in resistance of less than 1% from the
initial value
2512
2010
1206
0805
0603
General Note
TT Electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT Electronics’ own data and is considered accurate at time of going to print.
[i=s] This post was last edited by paulhyde on 2014-9-15 03:46 [/i] Does anyone have any good filter design software? Please recommend one, preferably one with tutorials. Thank you...
[i=s]This post was last edited by fish001 on 2019-9-19 21:50[/i]In the electronics industry, the crystal oscillator frequency that customers and suppliers often hear is 32.768KHZ, 77.503KHZ, 60.003KHZ...
I conducted the following experiment. Both can read and write data normally. The operation is to erase first and then write data. I erased the internal flash at 16K and the external flash at 64K. The ...
1. A clever way to clean plush toys without water: put half a bowl of coarse salt (coarse salt, available in supermarkets, 2 yuan a bag) and the dirty plush toys into a plastic bag, tie the mouth, and...
Usually in a feedback control system, we give the deviation between the reference and the measured quantity to the PID controller for adjustment, but the PID controller outputs an output quantity of a...
Embedded System
京公网安备 11010802033920号
EEWORLD
