-
1. Development Environment 1. Applicable chips: All STM32F4 chips 2. Firmware library: STM32F4xx_DSP_StdPeriph_Lib_V1.8.0 3，IDE：MDK517 2. Driver source code Delay.h...[Details]
-
Regarding the PHY construction of LWIP, the PHY chip used is LAN8720A, RMII mode. Regarding the hardware connection part, the Atomic board F407 is used, and the hardware connection is as follows: ...[Details]
-
At present, in the world,
the construction of
smart cities
is in the process of gradually landing from concept, and technology giants and investment giants are important participants in this...[Details]
-
The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]
-
When Amazon quietly launched a product called Elastic Computing Cloud 12 years ago, the Internet industry in China, across the ocean, also ushered in an unprecedented development opportunity. Let's...[Details]
-
pre name="code" class="cpp" uint32_t ADC_Detect(uint32_t AD_Channel) { hadc.Instance- CHSELR = 0; ADC_ChannelConfTypeDef sConfig; sConfig.Channel = AD_Channel; sConf...[Details]
-
In mid-to-late 2016, a girl from Hubei came to Beijing alone, full of curiosity about
cloud computing
. The girl left the deepest impression on me was her lovely smile. She told me that if ...[Details]
-
Pin Definition FSMC configuration steps 1. Enable the corresponding pin GPIO clock 2. Configure the GPIO pin mode 3. Enable the FSMC clock 4. FSMC initialization 5. Memory block enable Examp...[Details]
-
OSC_IN and OSC_OUT are external crystal pins by default. If you do not use an external crystal oscillator on the STM32, how to connect OSC_IN and OSC_OUT If you use the internal RC oscillator instead...[Details]
-
Proteus simulation circuit diagram C language program #include absacc.h #include reg52.h #define DA0832 XBYTE #define uchar unsigned char #define uint unsigned int ...[Details]
-
T1 or T2 are two timers/counters of MCS-51 microcontroller. The first method can use two timers/counters to generate rectangular waves. In order to save interface resources, the second method is used...[Details]
-
Using AT89S51 microcontroller, modify the original one to turn the LED on for 4s and off for 2s. Thank you. Use a timer. (The program is written in the answer, omitted here - just a note) The origi...[Details]
-
Design a second and minute pulse generator for a single-chip microcomputer using the interrupt method. Assume that P1.0 generates a positive pulse of one machine cycle per second, and P1.1 generates ...[Details]
-
Try to design a subroutine, whose function is to rearrange the 6 single-byte positive integers in the internal RAM pointed to by (R0) in ascending order. ;========================================== ...[Details]
-
I read the description of I/O ports in the M16 manual, which says that you can use the internal pull-up resistor by setting DDXn=0, PORTn=1, PUD=0. Since this can be used, when using the key circuit,...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
