How to measure the current of the primary of the switching power supply transformer with an oscilloscope? I only have an analog oscilloscope.
Is it only possible to use a digital oscilloscope to obser...
[i=s]This post was last edited by DDZZ669 on 2020-9-18 22:05[/i]The previous article " 【GD32450I-EVAL】+ 02 Software Development Environment Configuration (KEIL 5) and Running Light Test " introduced t...
I downloaded the STM8 library these two days and followed some instructions to add what should be added. There is an interrupt. I remember it is STM8-interrupt-vector.c. It is always automatically add...
[i=s]This post was last edited by littleshrimp on 2015-12-9 11:46[/i] Should the ADC driver in the figure be placed closer to the signal input terminal on the left or closer to the ADC on the right? I...
In the past week, I used the EP1C3T144C8 FPGA to embed NIOS2 and studied the drivers of FLASH and SDRAM. Finally, it was easy to use, but I encountered many twists and turns in the process. Now I will...
High efficiency and low standby power consumption are two major challenges in today's switching power supply design. Resonant topology or LLC topology is becoming increasingly popular because it ca...[Details]
With the rapid development of science and technology, especially the widespread application of digital technology and various ultra-large-scale integrated circuits, electronic equipment, especially...[Details]
1. Overview
Will passive devices
produce nonlinear intermodulation distortion? The answer is yes! Although there is no systematic theoretical analysis, it has been found in engineerin...[Details]
Abstract: In order to generate a stable excitation signal, the design of a digital frequency synthesizer is implemented on FPGA using Verilog hardware language. The design includes accumulator, wav...[Details]
With the development and widespread application of computer technology, especially in the field of industrial control, computer communication is particularly important. Although serial communication g...[Details]
Product series: PB-B-RS232/485 interface (hereinafter sometimes referred to as "interface") is a product in the PROFIBUS bus bridge series.
The main purpose of the bridge series ...[Details]
This controller uses PIC16C54 single-chip microcomputer as the controller, and it is very easy to use: just connect a telephone line to the loudspeaker through the controller, and you can rem...[Details]
introduction
MAX6636 is a multi-channel precision temperature monitor that can not only monitor local temperature, but also connect up to 6 diodes externally. Each channel has a programmable...[Details]
Investment in
the
medical device
industry has been on the rise in recent years. In the past two years, venture capital for medical devices has almost doubled, reaching $4 billion in 2007. Fr...[Details]
Recently, news came from the certification department that the photovoltaic grid-connected inverter of Samil New Energy Co., Ltd. (hereinafter referred to as "Samil New Energy") has once again obta...[Details]
LED guardrail lights use fluorescent tubes or LEDs as light sources and continuous guardrails as carriers to form an approximately linear guardrail light strip. This article mainly introduces...[Details]
0 Introduction
Pneumatic
artificial muscle,
also known as pneumatic muscle actuator (PMA), began to be studied in the 1950s. In recent years, it has been widely studied and applied ...[Details]
AUTOSAR is a hierarchical architecture for automotive electronic embedded software jointly launched by global automotive OEMs and suppliers. The hierarchical architecture consists of a microcontrol...[Details]
1. Low temperature storage
Lithium-ion power batteries need to be fully charged before storage. They can be stored at 20°C for more than half a year, which shows that lithium-ion power batteri...[Details]
As countries around the world are leaning towards the new energy battery industry, lithium-ion power batteries, as the ideal energy source for the development of the 21st century, are attracting mo...[Details]