-
0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]
-
The photovoltaic inverter is the core equipment of the photovoltaic system. Its main function is to convert the direct current generated by the photovoltaic modules into alternating current that meets...[Details]
-
Autonomous driving
and
5G
are the two hot topics that global companies and media are paying the most attention to, and the combination of the two is the focus of everyone's attention....[Details]
-
In 2018, the National Development and Reform Commission issued a new photovoltaic subsidy policy. The benchmark on-grid electricity price was significantly reduced, the return on investment decreased,...[Details]
-
In 1949, after three years of civil war, the Nationalist government was defeated and retreated to Taiwan. The political and academic circles launched a large-scale reflection on why they failed in ...[Details]
-
The analog watchdog of the ADC is used to check if the voltage is out of bounds. It has two upper and lower bounds, which can be set in the registers ADC_HTR and ADC_LTR respectively. The library fun...[Details]
-
1. Function and purpose There are two pins BOOT0 and BOOT1 on each STM32 chip. The level status of these two pins when the chip is reset determines which area the program starts from after th...[Details]
-
The storage media corresponding to the three boot modes of STM32 are built-in to the chip, they are: 1. User Flash = Flash built into the chip 2.SRAM = RAM area built into the chip, which is the m...[Details]
-
The code for using timer 0 to implement a running light in a 51 MCU is as follows. The LED light is connected to port P1. The code is annotated below, so I won't explain it in detail. My English is n...[Details]
-
The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]
-
When the program starts running, light A turns on for 5 seconds, then turns off, light B turns on for 5 seconds, light B turns off, light C turns on for 5 seconds, light C turns off, the program ends...[Details]
-
Proteus simulation circuit diagram C language program #include absacc.h #include reg52.h #define DA0832 XBYTE #define uchar unsigned char #define uint unsigned int ...[Details]
-
#include reg52.h #define PORTLEN P0 sbit bit_select = P2^0; sbit seg_select = P2^1; unsigned char src = {0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f ,0x6f,0x77,0x7c,0x39,0x5e,0x79,0x71}; unsigne...[Details]
-
/*----------------------------------------------- Name: Two-color dot matrix Forum: www.doflye.net Written by: shifang Modification: None Content: Using hc595 to drive two-color d...[Details]
-
Program ideas and defects reference: 51 single chip microcomputer (AT89C52) matrix keyboard detection program #include iom16v.h typedef unsigned char uchar; typedef unsigned int uint; #define ...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
