EEWORLDEEWORLDEEWORLD

Part Number

Search

270U824R501A1A1

Description
Commercial Miniature 5/8 (16mm) Diameter Composition Variable Resistors
File Size1MB,6 Pages
ManufacturerCTS [CTS Corporation]
Download Datasheet View All

270U824R501A1A1 Overview

Commercial Miniature 5/8 (16mm) Diameter Composition Variable Resistors

270U824R501A1A1 Preview

Series 270
®
Commercial
Miniature 5/8"
(16mm) Diameter
Composition
Variable Resistors
• Miniature 5/8" (16mm) size
• Versatile mounting styles:
– bushing
– twist tab
– bend tab
– snap-in PC bracket
– solder lug or PC terminals
(shaft parallel or perpendicular to the panel)
• 100
to 5 Meg
resistance range
• Molded or metal shafts
• SPST power switches
• Single, tandem, or concentric units
• Panel seal
• Rear extended shaft
Electrical and Mechanical Specifications
Resistance Range
100
through 5 Meg
(linear taper).
Resistance Tolerance
Standard: ±20%
Special: Other tolerances available in most
resistance values.
Power Rating, Watts
1
/
4
watt per section through 100K
1
/
5
watt per section above 100K
Full rating @ 55°C derated to no load at 85°C,
linear taper, bushing mounted control on steel panel
4" x 4" x .050" (101.6mm x 101.6mm x 1.27mm).
(Derating required on two section controls.)
Voltage Rating
Bushings to Terminals:
High pot test, one minute — 750 VAC
Operating maximum
— 500 VDC
Across End Terminals:
350 VDC, load not to exceed listed wattage ratings.
Resistance Tapers
Standard: Linear, 10% Audio and 10% CCW Audio
Special tapers available to meet most requirements
Angle of Rotation
Total Rotation
Without Switch: 300° ± 5°
With Switch:
315° ± 5°
Effective Rotation
Without Switch: 300° (approximate)
With Switch:
290° (approximate)
Panel Mounting Information
Bushing Mount
Standard: Brass
(continued on next page)
Technical Data Sheet 1448C
Technical Data Sheet 1270E
CTS CORPORATION /
MANUFACTURER OF RELIABLE ELECTRONIC COMPONENTS
Electrical and Mechanical Specifications
(continued)
All Other Mounts
Standard: Twist tab (designated by “1”)
Special: Bend tab — 2 or 3 ears
Bracket mounted
Suggested Panel for Twist Tab
.042" thick (1.07mm)
Locating Lugs (Bushing Mount)
Standard: .312" (7.9mm) radius from center of control.
Special: .375" (9.53mm) radius from center of control.
Standard Position: Left side supplied unless otherwise
specified.
Other Positions:
Available with lug right side,
without lugs, or with lugs both
left and right sides.
Water Seal Construction
Controls are also available to prevent water
from entering the control through either the
O.D. of shaft and/or the bushing.
Concentric Tandem Units
Available in two combinations:
A
– .125" (3.2mm) diameter rear shaft
.250" (6.35mm) panel shaft
(3/8 – 32 or M9X.75)
B
– .156" (4.0mm) diameter rear shaft
.236" (6.0mm) diameter panel shaft
(3/8 – 32 or M8X.75)
Most metal shaft diameters can be used with
twist tab mountings. With bracket mount,
only .187 diameter shafts are used, with turn-down
available to obtain smaller diameters.
Metal
Lengths: Minimum .125" (3.2mm) beyond bushing;
special lengths as required.
Trims:
Plain round screwdriver slotted, flatted,
knurled. Other trims available
upon request.
Molded
Flatted and knurled with screwdriver slot available
in many lengths and diameters.
Terminal Information
Standard: T Solder lug formed 90° to the rear.
Special:
(See below)
T:
T:
U:
Solder lug perpendicular to shaft.
Solder lug formed 60° to the rear.
PC terminals formed 90° forward toward
mounting surface. Terminals extend .187"
(4.7mm) beyond mounting surface.
PC terminals formed 90° to the rear, away
from panel mounting. Terminals extend .520"
(13.2mm) from mounting surface.
Shaft and Bushing Information
Bushing Lengths Available
Standard: .187" or .250" (4.75mm or 6.35mm)
Special: .125" increments (3.2mm increments)
Thread Size
Standard:
1
/
4
" – 32
3
/
8
" – 32
M7 x .75
M8 x .75P
Special: As required
Molded Shafts Available
(Shown with preferred diameter bushing)
Bushing Mounted or Ear Mounted
SHAFT DIAMETER
INCH
.156
.187
.236
.250
MM
4.0
4.7
6.0
6.35
BUSHING DIAMETER
INCH
1/4" – 32
3/8" – 32
3/8" – 32
MM
M7X.75
M7X.75
M8X.75
M9X.75
V:
W: Wire wrap terminals — .156" (4.0mm) terminal
extension beyond base, formed 60° to the rear.
BX: PC terminals standard .438" (11.1mm) from
center line of control to PC board; straight
terminals extend .156" (4.0mm) into PC board.
X:
PC terminals standard .505" (12.8mm) from
center line of control to PC board, with .136"
(3.4mm) straight terminal extension beyond
PC board standoff.
PC terminals standard .602" (15.3mm) from
centerline of control to PC board, with .140"
(3.5mm) straight terminal extension beyond
PC board standoff.
Metal Shafts Available
(Shown with preferred diameter bushing)
Single or Dual Units
SHAFT DIAMETER
INCH
.125
.156
.187
.236
.250
MM
3.2
4.0
4.7
6.0
6.35
BUSHING DIAMETER
INCH
1/4" – 32
1/4" – 32
3/8" – 32
3/8" – 32
3/8" – 32
MM
M7X.75
M7X.75
M7X.75
M8X.75
M9X.75
Y:
(continued on next page)
Electrical and Mechanical Specifications
(continued)
Power Switches Available
(all SPST)
SERIES
057
057
TYPE
Rotary
Rotary
ELECTRICAL
RATING
5A @ 20 VDC
3A @ 125 VAC
(UL approved)
Switch Actuating Angle -25˚
Switch Actuating Torque - 2 to 10 in. oz.
(144 to 720g-cm)
DIMENSION:
MM
INCH
SERIES
DEMI
DEMI
TYPE
Push-Pull
Momentary contact
Push on
ELECTRICAL
RATING
3A @ 20 VDC
3A @ 20 VDC
DIMENSION:
MM
INCH
T270
Solder Lug Terminals, Metal Shaft, Bushing Mount
DIMENSION:
MM
INCH
BX PM270
PC Type Base “X” Terminals, 2-Ear Mount Bend Tab, Molded Shaft
DIMENSION:
MM
INCH
UPE 270RE
PC Type “U” Terminals, Twist Tab Mount, Metal Shaft, Rear Extension
DIMENSION:
MM
INCH
XB275RE
PC Type “X” Terminals, Metal Shaft, Rear Extension
DIMENSION:
MM
INCH
VPE 270
PC Type “V” Terminals, Twist Tab Mount, Metal Shaft
DIMENSION:
MM
INCH
X057-BX270
PC Type Terminal SPST Switch, PC Style Base “X” Terminals, Metal Shaft, Bushing Mount
DIMENSION:
MM
INCH
T2-270
Solder Lug Terminals, Straight Tandem, Metal Shaft, Bushing Mount
DIMENSION:
MM
INCH
XP275
PC Type “X” Terminal, Metal Shaft, Twist Tab Mounting
DIMENSION:
MM
INCH
EEWORLD University ---- Tektronix and Altera jointly demonstrate 28-Gbps transceiver performance on Stratix V GT FPGA
Tektronix and Altera jointly demonstrate 28-Gbps transceiver performance on Stratix V GT FPGA : https://training.eeworld.com.cn/course/2134Introduces the 28nm Stratix V GT Signal Integrity Development...
chenyy FPGA/CPLD
Electromagnetic compatibility principles, technologies and applications
In order to adapt to the increasingly prominent electromagnetic interference problems and the mandatory implementation of electromagnetic compatibility standards, and to meet the needs of electrical i...
arui1999 Download Centre
Classic book recommendation: Detailed explanation of the core technology of radio frequency identification (RFID) in the Internet of Things
[align=center][size=14px][align=left][size=5][color=#ffa500][url=https://www.eeworld.com.cn/a17314]Detailed Explanation of the Core Technology of Radio Frequency Identification (RFID) in the Internet ...
高进 Download Centre
rtorrent terminal output issue after porting
Hello everyone, I compiled and installed a BT client rtorrent on the development machine (fedora11), which can run normally. When rtorrent runs normally, it will display the file being downloaded in t...
sanzhongren Embedded System
I made a version of STM8 development board, let me show it off.
I made a version of STM8 development board, show it to you. Please give me some comments.[[i] This post was last edited by yuyue_dl on 2012-11-22 23:50[/i]]...
yuyue_dl stm32/stm8
FPGA Program Optimization
I encountered a problem recently. Many pins were not displayed during simulation. My colleagues said that they were optimized away. I think it was because Quartus13.0 was not deciphered well. I would ...
franky1006 FPGA/CPLD

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 1384  1383  1500  2921  144  28  31  59  3  4 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号