Added information about Capacitive Touch controller
Added Backlight circuitry and Parallel TFT information
Corrected bezel information in section 2.1. Added additional
header information
Added link to FTDI/Bridgetek Programmers Guide
Initial Release
Author
Divino
Divino
Divino
Divino
Divino
Contents
Revision History .............................................................................................................................................................................. 1
1.1. Key Features .................................................................................................................................................................... 1
2. FTDI/Bridgetek EVE Chip............................................................................................................................................................. 2
2.1. FTDI/Bridgetek EVE Graphics Engine ............................................................................................................................... 2
3.1. Communication Header Pinout ....................................................................................................................................... 3
4. Communication Model ............................................................................................................................................................... 4
4.1. Programming Model ........................................................................................................................................................ 4
4.2. General Software Architecture ........................................................................................................................................ 4
5. Communication Interface ........................................................................................................................................................... 4
5.2. SPI and QSPI communication........................................................................................................................................... 5
5.3. Serial Data Protocol ......................................................................................................................................................... 6
9.1. Absolute Maximum Ratings ........................................................................................................................................... 11
9.2. EVE2 DC Characteristics ................................................................................................................................................. 11
9.3. EVE2 Digital I/O Pin Characteristics ............................................................................................................................... 11
9.4. Power Specifications ...................................................................................................................................................... 11
9.5. Touch Sense Characteristics........................................................................................................................................... 12
10.1. Matrix Orbital EVE2 series displays ............................................................................................................................. 12
10.2. Matrix Orbital Product Line Comparison ..................................................................................................................... 13
Use the following code to initialize void LCD_FSMCConfig(void) { FSMC_NORSRAMInitTypeDef FSMC_NORSRAMInitStructure; FSMC_NORSRAMTimingInitTypeDef p; /* FSMC_Bank1_NORSRAM1 timing configuration */ p.FS...
[i=s] This post was last edited by shaorc on 2017-12-4 11:00 [/i] [color=#444444][size=14px][font=Tahoma,]【If you don't understand, just ask】[/font][/size][/color] [color=#444444][size=14px][font=Taho...
In the sensor configuration routine, the corresponding frequency test program getFlicker.ino is provided. The result after compiling the program is shown in Figure 1.Figure 1 Frequency test procedure
...
2020-4-30-Today I sent the self-made bone sensor test circuit board PCB to the manufacturer for board making, and they told me that it can only be put into production after May 1st....
1. Overview
Will passive devices
produce nonlinear intermodulation distortion? The answer is yes! Although there is no systematic theoretical analysis, it has been found in engineerin...[Details]
Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
The reason for the light decay of white LEDs: the decline of phosphor performance
So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]
Introduction
Power subsystems are becoming more and more integrated into the overall system. Power systems have moved from being separate "essential dangerous devices" to being monitorable...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
A multi-point temperature control heating control system was designed using the SST89E564RC single-chip microcomputer and a new temperature measuring device. The heating system can be controlled in...[Details]
1 Introduction
Intelligent control instruments are one of the most commonly used controllers in industrial control. They are mainly aimed at a specific parameter (such as pressure, tempera...[Details]
my country is a big country in agriculture, grain production and consumption. Grains are a necessary condition for our nation to survive and develop. The flour processing industry will exist forever w...[Details]
This paper designs a 16x16LED Chinese character display bar based on single-chip dynamic scanning control, briefly analyzes the principle of Chinese character display, and studies how the LED displ...[Details]
1. Disadvantages of choosing too high a voltage level
Choosing too high a voltage level will result in too high an investment and a long payback period. As the voltage level increases, the...[Details]
With the widespread application of new services and technologies in the communications industry, the scale and capacity of operators' network construction are getting larger and larger, and the ris...[Details]
1 What is an LED floodlight?
LED downlights are also called spotlights, projection lamps, and spotlights. They are mainly used for architectural decorative lighting and commercial space lighti...[Details]
1 Introduction
The stepper motor is an actuator of an open-loop servo motion system, which is controlled in a pulse mode and outputs angular displacement. Compared with AC servo motors and DC servo ...[Details]
stm32/stm8
京公网安备 11010802033920号
EEWORLD
