Si1004-C
Ultra-Low Power 64 kB, 10-bit ADC
MCU with Integrated 240–960 MHz Transceiver
Supply Voltage: 0.9 to 1.8 V
-
Built-in dc-dc converter with 1.8 to 3.6 V output
-
Typical sleep mode current < 0.1 µA; retains state and RAM
contents over full supply range; fast wakeup of < 2 µs
Transceiver Features
-
-
-
-
-
Frequency range = 240–960 MHz
Sensitivity = –121 dBm
FSK, GFSK, and OOK modulation
Max output power = +13 dBm
RF power consumption
-
Two built-in brown-out detectors cover sleep and active modes
10-Bit Analog to Digital Converter
-
Up to 300 ksps
-
Up to 15 external inputs
-
External pin or internal VREF (no external capacitor required)
-
Built-in temperature sensor (±3 °C); no calibration required
-
External conversion start input option
-
Autonomous burst mode with 16-bit automatic averaging
accumulator
-
18.5 mA receive
-
30 mA @ +13 dBm transmit
-
18 mA @ +1 dBm transmit
-
-
-
-
-
-
-
Data rate = 0.123 to 256 kbps
Auto-frequency calibration (AFC)
Antenna diversity and transmit/receive switch control
Programmable packet handler
TX and RX 64 byte FIFOs
Frequency hopping capability
On-chip crystal tuning
Dual Comparators
-
Programmable hysteresis and response time
-
Configurable as interrupt or reset source
-
Low current (< 0.5 µA)
Memory
-
64 kB flash; in-system programmable in 1024-byte
sectors; full read/write/erase functionality over the entire
supply range
Digital Peripherals
-
19 port I/O
-
Hardware enhanced UART, SPI and I
2
C serial ports available
concurrently
-
Low power 32-bit smaRTClock
-
Four general purpose 16-bit counter/timers; six channel
programmable counter array (PCA)
-
4352 bytes internal data RAM (256 + 4K)
On-Chip Debug
-
On-chip debug circuitry facilitates full speed, non-intrusive in-
system debug (no emulator required)
Clock Sources
-
Precision internal oscillators: 24.5 MHz with ±2% accuracy sup-
ports UART operation; spread-spectrum mode for reduced EMI
High-Speed 8051 µC Core
-
Pipe-lined instruction architecture; executes 70% of instructions
in 1 or 2 system clocks
-
Low power 20 MHz internal oscillator
-
External oscillator: crystal, RC, C, CMOS clock
-
smaRTClock oscillator: 32.768 kHz crystal or self-oscillate
Ordering Part Number
-
Si1004-E-GM, 42-pin LGA (5 mm x 7 mm)
-
25 MIPS peak throughput with 25 MHz clock
Development Kit: Si1000DK-915, Si1000DK-470,
Si1002DK-868
Power On
Reset/PMU
Wake
Reset
CIP-51 8051
Controller Core
64k Byte ISP Flash
Program Memory
256 Byte SRAM
4096 Byte XRAM
Analog Peripherals
6-bit
IREF
Internal
VREF
External
VREF
A
M
U
X
VDD
VREF
Temp
Sensor
GND
CP0, CP0A
CP1, CP1A
+
-
+
-
RF XCVR
(240-960 MHz)
IREF0
PA
TX
AGC
C2CK/RST
Debug /
Programming
Hardware
C2D
VDD/DC+
GND/DC-
Power Net
Analog
Power
CRC
Engine
VREG
Digital
Power
SYSCLK
10-bit
300ksps
ADC
LNA
Mixer
PGA
ADC
RXp
RXn
Precision
24.5 MHz
Oscillator
DC/DC
Converter
Low Power
20 MHz
Oscillator
External
Oscillator
Circuit
smaRTClock
Oscillator
SFR
Bus
Comparators
Digital
Modem
Delta
Sigma
Modulator
Digital
Logic
Digital Peripherals
Transceiver Control Interface
VBAT
GND
UART
Timers 0,
1, 2, 3
PCA/
WDT
SMBus
SPI 0
Port I/O
Config
Priority
Crossbar
Decoder
19
OSC
XTAL1
XTAL2
XTAL3
XTAL4
XIN
XOUT
System Clock
Configuration
ANALOG &
DIGITAL I/O
Wireless MCU
Copyright © 2010 by Silicon Laboratories
1.15.10
Smart.
Connected.
Energy-Friendly
Products
www.silabs.com/products
Quality
www.silabs.com/quality
Support and Community
community.silabs.com
Disclaimer
Silicon Laboratories intends to provide customers with the latest, accurate, and in-depth documentation of all peripherals and modules available for system and software implementers
using or intending to use the Silicon Laboratories products. Characterization data, available modules and peripherals, memory sizes and memory addresses refer to each specific
device, and "Typical" parameters provided can and do vary in different applications. Application examples described herein are for illustrative purposes only. Silicon Laboratories
reserves the right to make changes without further notice and limitation to product information, specifications, and descriptions herein, and does not give warranties as to the accuracy
or completeness of the included information. Silicon Laboratories shall have no liability for the consequences of use of the information supplied herein. This document does not imply
or express copyright licenses granted hereunder to design or fabricate any integrated circuits. The products must not be used within any Life Support System without the specific
written consent of Silicon Laboratories. A "Life Support System" is any product or system intended to support or sustain life and/or health, which, if it fails, can be reasonably expected
to result in significant personal injury or death. Silicon Laboratories products are generally not intended for military applications. Silicon Laboratories products shall under no
circumstances be used in weapons of mass destruction including (but not limited to) nuclear, biological or chemical weapons, or missiles capable of delivering such weapons.
Trademark Information
Silicon Laboratories Inc., Silicon Laboratories, Silicon Labs, SiLabs and the Silicon Labs logo, CMEMS®, EFM, EFM32, EFR, Energy Micro, Energy Micro logo and combinations
thereof, "the world’s most energy friendly microcontrollers", Ember®, EZLink®, EZMac®, EZRadio®, EZRadioPRO®, DSPLL®, ISOmodem ®, Precision32®, ProSLIC®, SiPHY®,
USBXpress® and others are trademarks or registered trademarks of Silicon Laboratories Inc. ARM, CORTEX, Cortex-M3 and THUMB are trademarks or registered trademarks of
ARM Holdings. Keil is a registered trademark of ARM Limited. All other products or brand names mentioned herein are trademarks of their respective holders.
Silicon Laboratories Inc.
400 West Cesar Chavez
Austin, TX 78701
USA
http://www.silabs.com
京公网安备 11010802033920号
EEWORLD
