Specifications are subject to change without notice.
Revised: 08/30/17
Thyristors
Surface Mount – 200V-600W > 2N6071A/B Series
Maximum Ratings and Thermal Characteristics
(T
J
= 25°C unless otherwise noted)
Rating
Symbol
Value
Unit
*Peak Repetitive Off-State Voltage (Note 1)
(T
J
= -40 to 110°C, Sine Wave, 50 to 60 Hz, Gate Open)
2N6071A,B
2N6073A,B
2N6075A,B
*On-State RMS Current (T
C
= 85°C) Full Cycle Sine Wave 50 to 60 Hz
*Peak Non-repetitive Surge Current (One Full cycle, 60 Hz, T
J
= +110°C)
Circuit Fusing Considerations (t = 8.3 ms)
*Peak Gate Power (Pulse Width “1.0 µs, T
C
= 85°C)
*Average Gate Power (t = 8.3 ms, T
C
= 85°C)
*Peak Gate Voltage (Pulse Width “1.0 µs, T
C
= 85°C)
*Operating Junction Temperature Range
*Storage Temperature Range
Mounting Torque (6-32 Screw) (Note 2)
V
DRM
,
V
RRM
200
400
600
I
T(RMS)
I
TSM
I
2t
P
GM
P
G(AV)
V
GM
T
J
T
stg
_
4.0
30
3.7
10
0.5
5.0
-40 to +110
-40 to +150
8.0
A
A
A2s
W
W
V
°C
°C
in. lb.
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the Recommended Operating Conditions is not implied.
Extended exposure to stresses above the Recommended Operating Conditions may affect device reliability.
1. V
DRM
and V
RRM
for all types can be applied on a continuous basis. Blocking voltages shall not be tested with a constant current source such that the voltage ratings of the devices are exceeded.
2. Torque rating applies with use of a compression washer. Mounting torque in excess of 6 in. lb. does not appreciably lower case-to-sink thermal resistance. Main terminal 2 and heatsink
contact pad are common.
Thermal Characteristics
Rating
*Thermal Resistance, Junction to Case
Thermal Resistance, Junction to Ambient (Note 1)
Maximum Lead Temperature for Soldering Purposes, 1/8” from case for
[i=s]This post was last edited by Yangfanqihang on 2014-2-17 18:25[/i] [font=楷体,楷体_GB2312][size=4][color=red]This is the first time I use Skywalker ESC and brushless motor. There is very little inform...
Now as I learn more, I find that debugging the driver often requires the cooperation of the application. Could you please recommend some good wince application development books, preferably those deve...
How can I disable the CAN send interrupt and only allow the receive interrupt? I have tried to set: CANIntEnable(CAN0_BASE, CAN_INT_MASTER | CAN_INT_ERROR | CAN_INT_STATUS); sCANMessage.ulFlags = 0; /...
This content is originally created by EEWORLD forum user Qi IC Kan MCU . If you want to reprint or use it for commercial purposes, you must obtain the author's consent and indicate the sourceICC , whi...
Because I need to start learning PDA development, I have no application development foundation, and I don't know much about PDA's operating system platform. I saw Palm, Sybian, and WinCE. I heard that...
stm32/stm8
京公网安备 11010802033920号
EEWORLD
