TB67H410FTG , TB67H410NG
TOSHIBA BiCD Integrated Circuit Silicon Monolithic
TB67H410FTG, TB67H410NG
PWM Chopper-Type
Brushed DC Motor driver
The TB67H410 is brushed DC motor driver of a PWM chopper-type.
The TB67H410 is a dual channel H-SW driver which can control
two brushed DC motors. Moreover, the parallel control function (La
rge mode) of an output part is built in, and 1ch high current drive is
also possible.Fabricated with the BiCD process, the TB67H410 is
maximum rated at 50V,2.5A(2ch)/5.0A(1ch).
FTG
・Monolithic
motor driver using BiCD process.
・Capable
of controlling two brushed DC motor.
・2
drive modes (PWM controlled constant-current/ direct PWM)
・4
operation modes (Clock-wise/Counter clock-wise/Brake/Stop(Off))
・Low
on-resistance output stage (High side+Low side:0.8Ω(typ.))
・High
voltage and current (for specification, please refer to absolute
maximum ratings and
operating ranges.)
・Built-in
error detection circuits (Thermal shutdown(TSD), over-current
detection (ISD), and power-on reset (POR).
・Built-in
regulator allows the TB67H410 to function with a single VM
power supply.
・Able
to customize PWM (internal chopping) frequency by external
components.
・Multi
package lineup.
TB67H410FTG: P-WQFN48-0707-0.50-003
TB67H410NG: P-SDIP24-0723-1.78-001
Features
P-WQFN48-0707-0.50-003
Weight: 0.10g (typ.)
NG
P-SDIP24-0723-1.78-001
Weight: 1.3g (typ.)
Note: Please be careful about the thermal conditions during use.
©2014 Toshiba Corporation
1
2015-1-27
TB67H410FTG , TB67H410NG
Notes:
All the grounding wires of the TB67H410 must run on the solder within the mask of the PCM. It must also be
externally terminated at a single point. Also, the grounding method should be considered for efficient heat dissipation.
Careful attention should be paid to the layout of the output, VM and GND traces, to avoid short circuits across output
pins or to the power supply or ground. If such a short circuit occurs, the device may be permanently damaged.
Also, the utmost care should be taken for pattern designing and implementation of the device since it has power
supply pins (VM, RS, OUT, GND) through which a particularly large current may run. If these pins are wired
incorrectly, an operation error may occur or the device may be destroyed.
The logic input pins must also be wired correctly. Otherwise, the device may be damaged owing to a current running
through the IC that is larger than the specified current.
5
2015-1-27
Energy Infrastructure?
京公网安备 11010802033920号
EEWORLD
