High Sensitivity, 1 MHz, GMR-Based Current Sensor IC
in Space-Saving, Low Resistance QFN and SOIC-8 Packages
FEATURES AND BENEFITS
•
High sensitivity current sensor IC for sensing
up to 5 A (DC or AC)
•
1 MHz bandwidth with response time <550 ns
•
Low noise: 8 mA(rms) at 1 MHz
•
Non-ratiometric, analog output proportional to AC and
DC current
•
Single 3.3 V supply operation
•
High DC PSRR enables use with low accuracy
power supplies or batteries (3 to 4.5 V operation)
• 1.1 mΩ primary conductor resistance results in
low power loss
•
Small surface mount QFN-12 and SOIC-8 packages for
space-constrained applications
DESCRIPTION
The ACS70331 is Allegro’s first integrated, high sensitivity,
current sensor IC for <5 A current sensing applications. It
incorporates giant magneto-resistive (GMR) technology that
is 25 times more sensitive than traditional Hall-effect sensors
to sense the magnetic field generated by the current flowing
through the low resistance, integrated primary conductor.
The analog output provides a low noise high-speed signal,
which is proportional to the current flowing through the
primary. The response time of the part is typically 535 ns. The
ACS70331 is offered in four factory-programmed sensitivity
and offset levels to optimize performance over the desired
current measurement range.
The differential configuration of the GMR elements, relative to
the integrated current conductor, provides significant rejection
of stray magnetic fields, resulting in stable operation even in
magnetically noisy environments.
The ACS70331 operates from a single 3.3 V power supply
and is qualified over the full commercial temperature range
of –40°C to 85°C. It is offered in a low-profile, space-saving
surface mount QFN-12 and SOIC-8 packages.
PACKAGES
12-contact QFN
3 mm × 3 mm × 0.75 mm
(ES package)
Not to scale
8-contact SOIC
(OL package)
TYPICAL APPLICATION
C
BYPASS
0.1 µF
12
1
IP+
IP+
VCC
11
NC
VIOUT
10
C
LOAD
IP
NC
NC
8
3
IP -
2
IP+
VIOUT
7
1
IP+
VCC
8
C
BYPASS
0.1 µF
2
IP
ACS70331
NC
9
ACS70331
NC
3
4
IP–
IP–
6
7
GND
5
NC
6
4
IP -
GND
5
QFN-12
The output, VIOUT, of the ACS70331 responds
proportionally to the current flowing through IP.
SOIC-8
ACS70331-DS, Rev. 2
MCO-0000343
May 23, 2018
ACS70331
SELECTION GUIDE
Part Number
ACS70331EESATR-2P5U3
ACS70331EESATR-2P5B3
ACS70331EESATR-005U3
ACS70331EESATR-005B3
ACS70331EOLCTR-2P5U3
ACS70331EOLCTR-2P5B3
ACS70331EOLCTR-005U3
ACS70331EOLCTR-005B3
[1]
High Sensitivity, 1 MHz, GMR-Based Current Sensor IC
in Space-Saving, Low Resistance QFN and SOIC-8 Packages
Current Sensing
Range, I
PR
(A)
0 to 2.5
±2.5
0 to 5
±5
0 to 2.5
±2.5
0 to 5
±5
Sens (Typ)
(mV/A)
800
400
400
200
800
400
400
200
T
A
(°C)
Package
12-contact
QFN with fused
current loop
Packing
[1]
–40 to 85
1500 pieces per reel
–40 to 85
8-lead SOIC
3000 pieces per reel
Contact Allegro for additional packing options.
ABSOLUTE MAXIMUM RATINGS
Characteristic
Supply Voltage
Reverse Supply Voltage
Output Voltage
Reverse Output Voltage
Working Voltage
Maximum Continuous Current
[2]
Maximum Continuous External Field
[3]
Nominal Operating Ambient Temperature
Maximum Junction Temperature
[2]
Storage Temperature
[2]
Continuous
Symbol
V
CC
V
RCC
V
IOUT
V
RIOUT
V
WORKING
I
P(max)
B
T
A
T
J
(max)
T
stg
Range E
Notes
Rating
7
–0.1
6
–0.1
Units
V
V
V
V
V
A
G
°C
°C
°C
Voltage applied between pins 1 to 4 and pins 5 to 12 (QFN)
or pins 1 to 4 and pins 5 to 8 (SOIC)
100
±10
±50
–40 to 85
100
–65 to 125
currents above this may result in changes in performance. See lifetime drift section for sensor drift under different temperature and current conditions. Also,
see Thermal Performance and Overcurrent Capability section for allowable constant and transient currents.
[3]
Continuous magnetic fields above this may result in changes in performance.
[4]
The ACS70331 should be soldered using Allegro’s recommended soldering profile in (http://www.allegromicro.com/en/Design-Center/Technical-Documents/Semicon-
[i=s]This post was last edited by qwqwqw2088 on 2021-5-19 08:50[/i]Supercapacitors are becoming more and more popular in many applications due to their charging times, better transient performance, si...
I recently debugged the API of a car ecu, the 14230 protocol. I found a problem, there is data on the bus but the interface cannot reach it, I don't know why. Please give me some advice, thank you!...
[font=Times New Roman] [/font] [font=宋体] The economic crisis seems to have spread to every corner of the world, and the [/font][font=Times New Roman]IC[/font][font=宋体] industry has not been spared. Ev...
Traditional broadcasting systems generally need to be operated manually at a fixed time, and can only realize one-way broadcasting with few functions. Traditional bell ringing equipment has a singl...[Details]
1 Introduction
The high temperature tester is mainly used for temperature tracking measurement and data acquisition during the heating process. By systematically analyzing the test data, the...[Details]
1. Circuit composition
The whole circuit consists of two parts:
1. Power saving control circuit
As shown in the figure below. Including delay circuit and drive circuit.
(1) Delay ci...[Details]
1. Introduction
With the growth of parking demand, the scale of parking lots is becoming larger and larger. A lot of research has been done on intelligent parking lots in China, but most of th...[Details]
Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]
Converged processors meet scalability requirements
In current embedded system design, solutions based on MCU, DSP, FPGA and ASIC account for more than 90% of the market share. These solutions ...[Details]
The reason for the light decay of white LEDs: the decline of phosphor performance
So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]
Battery life is critical for portable applications. For applications such as smoke detectors, security devices, and thermostats, factory-installed batteries need to last for more than 10 years. The...[Details]
We know that microcontroller development tools generally include real-time online emulators and programmers. Among them, online emulators are very good tools, but they are also more expensive...[Details]
With the advocacy and implementation of the government's Safe City Plan, the security market has increasingly higher requirements for the clarity of surveillance images. Imagine that after a case o...[Details]
Printed circuit boards ( PCBs
)
are used in most electrical products
. If a PCB has low
insulation resistance
(IR), the performance of the circuits on the PCB will be greatly reduced...[Details]
Today, with energy becoming increasingly scarce, the utilization of natural energy has become the focus of people's attention. Among various natural energies, the endless solar energy is highly fav...[Details]
With the rapid development of cities and the improvement of citizens' living standards, the number of various vehicles in cities is growing, and the demand for parking spaces in major commercial an...[Details]
0 Introduction
Ultrasonic waves
are mechanical waves with a frequency of more than 20KHz, and the propagation speed in the air is about 340 m/s (at 20°C). Ultrasonic waves can be gene...[Details]
Electric bicycles have long been a means of transportation for lower-income groups due to their affordability. The largest concentrated expense in the use of electric vehicles is the cost of replac...[Details]
ADI Reference Circuit
京公网安备 11010802033920号
EEWORLD
