Maximum; 20% to 80% x VDD; Output load (CL) = 4 pF
Worst case; output frequencies ≤ 100 MHz
Worst case; output frequencies > 100 MHz
Output valid time after VDD meets the specified range & STBY# transition
Output load (CL) = 4 pF; 75 MHz
Output load (CL) = 4 pF; 75 MHz; measured over 12 K cycles
6.144
20
49.152
125
7.3728
22.5972
50
133
8
24
60
10
24.576
62.5
12
25
66
12.5
30
66.66
12.288
33
72
14.31818
33.333
74.25
Output Frequency
F
OUT
4
4.096
5
6
15
16
18.432
19.44
36
37.5
40
48
75
80
98.304
100
Contact IDT for additional frequencies
Note: Above specifications are typical at room temperature (25°C ) unless otherwise specified.
* Inclusive of initial frequency accuracy, operating temperature range, supply variation, load variation, 3 times solder reflow, shock, vibration and 5 years aging at 25°C.
may cause permanent damage to the device. These ratings are
stress specifications only. Functional operation of product at
these or under any condition beyond those listed in the
operating specifications is not implied. Exposure to absolute
maximum rated conditions may affect product reliability.
Item
VDD
STBY#
OUT
Storage Temperature
Solder Reflow Profile
40 sec (max)
250
200
150
100
50
150°C
60-180
sec
(260°C max)
245°C
217°C
s c
/sec
°
/
6
°
C
60-150
sec
a
ma x
4.6 V
-0.5 V to VDD + 0.5 V
-0.5 V to VDD + 0.5 V
-65°C to 150°C
3
°
C/
se
Maximum Absolute Rating
cm
ax
Time
Pin Descriptions
Pin #
1
2
3
4
Output Waveform
Description
T
R
0.8 VDD
T
F
V
OH
Name
STBY#
GND
OUT
2
VDD
Standby Mode
1
(0 = Output Disabled)
Ground
CMOS Output
Power
1. Pulled high internally
2. Weak pull down to GND during STBY# enable and startup
0.5 VDD
0.2 VDD
V
OL
SYM = t
1
/ t
2
t
1
t
2
Ordering Information
3CN11G
Frequency
4 to 133MHz*
4.09600
22.5792
133.000
NSG
E
8
Package
Suffix
NSG
Minimum Order Quantity (MOQ)
T&R
Bulk
2500
3000
1260 (18 Tubes)
1250 (Canister)
Factory Order Increment (FOI)
T&R
Bulk
2500
3000
1260 (18 Tubes)
1250 (Canister)
Package
NSG: 5.0 x 3.2 x 0.85
CVG: 2.5 x 2.0 x 0.85
C:
E:
Temp
0 to 70°C
-20 to 70°C
Shipping
Blank: Tubes
8:
Tape and Reel
CVG
* See frequency table or contact IDT
6024 Silver Creek Valley Road
San Jose, California 95138
Sales
800-345-7015 (inside USA)
+1 408-284-8200 (outside USA)
Fax: 408-284-2775
Technical Support
crystalfreetechsupport@idt.com
+1 408-360-5656
DISCLAIMER Integrated Device Technology, Inc. (IDT) and its subsidiaries reserve the right to modify the products and/or specifications described herein at any time and at IDT’s sole discretion. All information in this document,
including descriptions of product features and performance, is subject to change without notice. Performance specifications and the operating parameters of the described products are determined in the independent state and are not
guaranteed to perform the same way when installed in customer products. The information contained herein is provided without representation or warranty of any kind, whether express or implied, including, but not limited to, the
suitability of IDT’s products for any particular purpose, an implied warranty of merchantability, or non-infringement of the intellectual property rights of others. This document is presented only as a guide and does not convey any
license under intellectual property rights of IDT or any third parties.
IDT’s products are not intended for use in life support systems or similar devices where the failure or malfunction of an IDT product can be reasonably expected to significantly affect the health or safety of users. Anyone using an
IDT product in such a manner does so at their own risk, absent an express, written agreement by IDT.
Integrated Device Technology, IDT and the IDT logo are registered trademarks of IDT. Other trademarks and service marks used herein, including protected names, logos and designs, are the property of IDT or their respective
The CMD file is a linker command file (Linker Command File) with the suffix .cmd.Before analyzing cmd files, you must first understand(1) the memory map of the DSP chip (Memory Map)(2) the knowledge o...
My power input is 4 dry batteries totaling 6V, which are used to stabilize the voltage of AMS1117-3.3 to 3.3V. Previously, the input and output of the voltage regulator were connected to filter capaci...
Hello everyone, I am using a high-frequency transistor as a diode to limit a signal, as shown in Figure 3, the input signal is shown in Figure 2, and the output signal is shown in Figure 1. I have nev...
I designed a low-power product using Bluetooth 4.0. The CSR1010 chip used has a transmit power of +4dBm and a broadcast interval of 60mS. According to CSR testing, the radio power consumption is about...
Dual-mode inverters can operate both in conjunction with the grid and independently. These inverters can inject excess energy from renewable energy and storage devices into the grid, and withdraw p...[Details]
A parallel inverter consists of two thyristors (T1 and T2), a capacitor, a center-tapped transformer, and an inductor. The thyristors provide a current path, while the inductor L maintains a consta...[Details]
A vacuum eutectic furnace is a critical piece of equipment used in the manufacturing and processing of various materials, particularly in the fields of microelectronics and nanotechnology. One of t...[Details]
In recent years, many people have switched to new energy vehicles, and this type of vehicle has indeed been highly sought after and is considered the future direction of automobile development, and...[Details]
summary
There are multiple approaches to making industrial systems more intelligent, including applying artificial intelligence (AI) technology at the edge and in the cloud to sensor...[Details]
1 Introduction
In the mid-1960s, American scientist Maas conducted extensive experimental research on the charging process of open-cell batteries and proposed an acceptable charging curve for ...[Details]
According to foreign media reports, Nissan Motor has recently reached a cooperation with US battery technology company LiCAP Technologies to jointly promote the research and development of next-gen...[Details]
In June 2014, the Ministry of Industry and Information Technology issued 4G FD-LTE licenses to China Unicom and China Telecom. Together with the 4G TD-LTE licenses issued to China Mobile, China Uni...[Details]
Electric vehicles' 12V batteries don't rely on a generator to power them. Only gasoline-powered vehicles rely on the engine to drive a generator to generate electricity while driving, which is used...[Details]
A patent disclosed by Ford proposes replacing traditional segmented side curtain airbags with integrated full-width side curtain airbags that span the side of the vehicle and can be deployed simult...[Details]
MQTT Ethernet I/O modules primarily collect I/O port information and transmit data over the network. In addition to being a TCP server, Ethernet I/O modules can also function as TCP clients. Furthe...[Details]
Lightweighting of automobiles is still a relatively unfamiliar term for automobiles. With the continuous improvement of environmental protection requirements, relevant regulations have also put for...[Details]
The driving mode is not unfamiliar to vehicles. According to the driving mode of the vehicle, there are front-wheel drive, rear-wheel drive and even four-wheel drive. Four-wheel drive is a major se...[Details]
Analog Devices held a third-quarter fiscal 2025 earnings conference call. Vincent T. Roche, CEO and Chairman of the Board, and Richard C. Puccio, Executive Vice President and Chief Financial Office...[Details]
I believe everyone has heard of memory. If your computer is slow, your experts may recommend upgrading it to a larger capacity. But what exactly is computer memory used for? Why does memory capacit...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
