1. 20 MHz bandwidth oscilloscope, 12” of twisted load cables paralleled with 0.1 µF ceramic and 47 µF electrolytic capacitors placed across the terminals at the load.
2. At 230 Vac, 50 Hz, full load.
3. All specifications are measured at Ta=25°C, nominal input voltage, and rated output load unless otherwise specified.
PART NUMBER KEY
VGS-75B
-
XX
Base Number
Output Voltage
cui.com
For more information, please visit the
product page.
CUI Inc
│
SERIES:
VGS-75B
│
DESCRIPTION:
AC-DC POWER SUPPLY
date
06/20/2018
│
page
2 of 5
INPUT
parameter
voltage
frequency
current
inrush current
leakage current
no load power consumption
at 230 Vac
at 115 Vac input, full load
at 230 Vac input, full load
at 230 Vac input, cold start, full load
conditions/description
min
90
47
typ
max
264
63
1.7
1.0
50
3.5
0.4
units
Vac
Hz
A
A
A
mA
W
OUTPUT
parameter
line regulation
load regulation
adjustability
start-up time
rise time
hold-up time
switching frequency
conditions/description
12 Vdc output model
all other models
12 Vdc output model
all other models
built in trim pot
at 115/230 Vac input, full load
at 115/230 Vac input, full load
at 115 Vac input, full load
at 230 Vac input, full load
12
30
65
±10
2
40
min
typ
max
±1
±0.5
±1
±0.5
units
%
%
%
%
%
s
ms
ms
ms
kHz
PROTECTIONS
parameter
over voltage protection
over current protection
short circuit protection
conditions/description
output shutdown, must recycle power to recover
output shutdown, auto recovery
output shutdown, auto recovery
min
120
110
typ
max
145
150
units
%
%
SAFETY & COMPLIANCE
parameter
isolation voltage
conditions/description
input to output for 1 minute, 10 mA
input to ground for 1 minute, 10 mA
output to ground for 1 minute, 10 mA
input to output at 500 Vdc
input to ground at 500 Vdc
output to ground 500 Vdc
IEC/EN 60950-1, UL 60950-1
class I
EN 55032:2015, Class B
EN 55032:2015, Class B
EN 61000-3-2:2014, Class A
EN 61000-3-3:2013, Class A
IEC 61000-4-2, air: ±8 kV; contact: ±4 kV, Class A
IEC 61000-4-3, 3 V/m, Class A
IEC 61000-4-4, Ac power port: 1 kV;
signal & telecommunication ports: 0.5 kV, Class B
100
100
100
min
typ
1,500
1,500
500
max
units
Vac
Vac
Vac
MΩ
MΩ
MΩ
isolation resistance
safety approvals
safety class
conducted emissions
radiated emissions
input current harmonics
voltage fluctuation and flicker
ESD immunity
radiated field immunity
electrical fast transient
immunity
Notes:
1. The power supply is considered a component which will be installed into final equipment. The final equipment still must be tested to meet the necessary EMC directives.
cui.com
For more information, please visit the
product page.
CUI Inc
│
SERIES:
VGS-75B
│
DESCRIPTION:
AC-DC POWER SUPPLY
date
06/20/2018
│
page
3 of 5
SAFETY & COMPLIANCE (CONTINUED)
parameter
surge immunity
conducted immunity
magnetic field immunity
voltage dips, interruptions
MTBF
RoHS
Notes:
conditions/description
IEC 61000-4-5, input L to input N: 1 kV;
input L to FG: 2 kV; input N to FG: 2 kV, Class C
IEC 61000-4-6, frequency range: 0.15~80 MHz;
field strength: 3 Vms, Class A
IEC 61000-4-8, 1 A/m, Class A
IEC 61000-4-11:
voltage dips >95% reduction, 0.5 period, Class A
voltage dips 30% reduction, 25 period, Class B
voltage dips >95% reduction, 250 period, Class C
as per MIL-HDBK-217F, 25°C
yes
min
typ
max
units
200,000
hours
1. The power supply is considered a component which will be installed into final equipment. The final equipment still must be tested to meet the necessary EMC directives.
The revision history provided is for informational purposes only and is believed to be accurate.
date
06/20/2018
Headquarters
20050 SW 112th Ave.
Tualatin, OR 97062
800.275.4899
CUI offers a two (2) year limited warranty. Complete warranty information is listed on our website.
Fax 503.612.2383
cui.com
techsupport@cui.com
CUI reserves the right to make changes to the product at any time without notice. Information provided by CUI is believed to be accurate and reliable. However, no responsibility is
assumed by CUI for its use, nor for any infringements of patents or other rights of third parties which may result from its use.
CUI products are not authorized or warranted for use as critical components in equipment that requires an extremely high level of reliability. A critical component is any component of a
life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness.
Error: Could not find file 'D:\WINCE420\PUBLIC\SMDK2410\RelDir\SAMSUN~1\TEST_SPL.dll' on disk But the path I defined in platform.bib is TEST_SPL.dll D:\WINCE420\TEST_SPL.dll NK SH Please help...
The first time I came into contact with MSP430 was when I was preparing to participate in this year's Jiangsu TI provincial power competition. At that time, the power competition had not yet officiall...
As the title says, this is my first time designing FPGA. I have references for most of the designs before. This time I chose the XC5VSX95T chip, and I don't use the GTP_DUAL module. Do these unused mo...
I need to use a lot of long integers in my application. When programming, I found that if I define several long integers, there is no problem in doing addition and subtraction, and there will be no ov...
The rapid development of the Internet has realized high-speed information transmission and resource sharing, greatly facilitating people's lives. Embedded systems are widely used in various electr...[Details]
introduction
Solar cells and LED lighting are typical applications of new energy and energy-saving and efficient technologies. Solar LED lighting uses solar cells to convert solar energy...[Details]
Editor's note: In order to help technicians or engineers who have knowledge of PIC microcontroller assembly language quickly master the method of using C language to program PIC microcontrollers, t...[Details]
General LED lighting has a current limiting resistor in the driving circuit, and the power consumed by the resistor has nothing to do with the LED light emission. In order to improve efficiency, a...[Details]
Among the many members of the single-chip microcomputer family, the MCS-51 series of single-chip microcomputers has occupied the main market of industrial measurement and control and automation eng...[Details]
From the previous section, we have learned that the timer/counter in the microcontroller can have multiple uses, so how can I make them work for the purpose I need? This requires setting the timer/...[Details]
Capacitors
are basic components in various electronic devices and are widely used for bypassing, coupling,
filtering
, tuning, etc. in electronic circuits. However, to use capacitors,...[Details]
Introduction
As the country increases its efforts to control the atmospheric environment, motorcycle emission regulations will become stricter year by year, and motorcycles that do not meet the...[Details]
Introduction
Today, as IC (integrated circuit) has developed to a super-large scale, IC design based on IP (Intellectual Property) cores and their reuse are important means to ensure the ef...[Details]
Zarlink Semiconductor has developed an ultra-low-power RF transceiver chip for pacemakers, neurostimulators, drug pumps, and other such implantable medical devices. It has high data rates, low power c...[Details]
The future energy storage hotspot is not coal or iron ore, but lithium. This lightest metal in nature may be the heaviest resource in the future energy landscape. China launched an ambitious electr...[Details]
Features
POE technology can ensure the safety of existing structured cabling while ensuring the normal operation of the existing network and minimizing costs. The IEEE 802.3af standard is ...[Details]
1 Introduction
At present, people have higher and higher requirements for the quality of life. When people are busy with work, soymilk machine is a new type of household beverage machine. It uses so...[Details]
1. Advantages of CAN-bus in coal mine communication
Coal mine production is a field closely related to the national economy and people's livelihood. Among them, coal mine safety is undoubtedly ...[Details]
introduction
The air compressor unit in the operating area of a lead-zinc mine in Guangdong is a key equipment in mining production. There are six imported Ingersoll Rand CENTAC air compress...[Details]
Embedded System
京公网安备 11010802033920号
EEWORLD
