≤ +500 mV, GNEG = 0 V, –10 dB to +30 dB gain range, R
L
= 500 Ω, and C
L
= 5 pF, unless
otherwise noted.
Table 1.
Parameter
INPUT CHARACTERISTICS
Input Resistance
Input Capacitance
Input Noise Spectral Density
1
Noise Figure
1 dB Compression Point
Peak Input Voltage
OUTPUT CHARACTERISTICS
−3 dB Bandwidth
Slew Rate
Peak Output
2
Output Impedance
Output Short-Circuit Current
Group Delay Change vs. Gain
Group Delay Change vs. Frequency
Differential Gain
Differential Phase
Total Harmonic Distortion
Third-Order Intercept
ACCURACY
Gain Accuracy, f = 100 kHz; Gain (dB) = (40 V
G
+ 10) dB
T
MIN
to T
MAX
Gain, f = 10.7 MHz
Output Offset Voltage
3
T
MIN
to T
MAX
Output Offset Variation vs. V
G
T
MIN
to T
MAX
GAIN CONTROL INTERFACE
Gain Scaling Factor
T
MIN
to T
MAX
GNEG, GPOS Voltage Range
Input Bias Current
Input Offset Current
Differential Input Resistance
Response Rate
POWER SUPPLY
Specified Operating Range
Quiescent Current
T
MIN
to T
MAX
1
Conditions
Pin 3 to Pin 4
Input short-circuited
f = 10 MHz, gain = maximum, R
S
= 10 Ω
f = 10 MHz, gain = maximum, R
S
= 10 Ω
V
OUT
= 100 mV rms
R
L
≥ 500 Ω
R
L
≥ 500 Ω
f ≤ 10 MHz
f = 3 MHz; full gain range
V
G
= 0 V; f = 1 MHz to 10 MHz
f = 10 MHz, V
OUT
= 1 V rms
f = 40 MHz, gain = maximum, R
S
= 50 Ω
−500 mV ≤ V
G
≤ +500 mV
V
G
= -0.5 V
V
G
= 0.0 V
V
G
= 0.5 V
V
G
= 0 V
−500 mV ≤ V
G
≤ +500 mV
100 kHz
10.7 MHz
Min
97
Typ
100
2
1.3
8.8
−11
±1.4
90
275
±3.0
2
50
±2
±2
0.2
0.2
−60
15
±0.5
−9.0
+10.5
+30.3
Max
103
Unit
Ω
pF
nV/√Hz
dB
dBm
V
MHz
V/µs
V
Ω
mA
ns
ns
%
Degree
dBc
dBm
±2
±2.5
−1
−1.5
−10.3
+9.5
+29.3
+1
+1.5
−8.0
+11.5
+31.3
20
30
20
30
40.6
42
39.9
+2.0
250
dB
dB
dB
dB
dB
mV
mV
mV
mV
dB/V
dB/V
dB/V
V
nA
nA
MΩ
dB/µs
V
mA
mA
4
39.4
38
38.7
−1.2
50
40
39.3
100
10
50
80
12.5
Pin 1 to Pin 2
Full 40 dB gain change
±4.75
±6.3
17
20
Typical open or short-circuited input; noise is lower when system is set to maximum gain and input is short-circuited. This figure includes the effects of both voltage
and current noise sources.
2
Using resistive loads of 500 Ω or greater or with the addition of a 1 kΩ pull-down resistor when driving lower loads.
3
The dc gain of the main amplifier in the AD603 is ×35.7; therefore, an input offset of 100 µV becomes a 3.57 mV output offset.
4
GNEG and GPOS, gain control, and voltage range are guaranteed to be within the range of −V
S
+ 4.2 V to +V
S
− 3.4 V over the full temperature range of −40°C to +85°C.
Rev. K | Page 3 of 24
AD603
ABSOLUTE MAXIMUM RATINGS
Table 2.
Parameter
Supply Voltage ±V
S
Internal Voltage VINP (Pin 3)
GPOS, GNEG (Pin 1 and Pin2)
Internal Power Dissipation
Operating Temperature Range
AD603A
AD603S
Storage Temperature Range
Lead Temperature (Soldering, 60 sec)
Rating
±7.5 V
±2 V Continuous
±V
S
for 10 ms
±V
S
400 mW
−40°C to +85°C
−55°C to +125°C
−65°C to +150°C
300°C
Data Sheet
Table 3. Thermal Characteristics
Package Type
8-Lead SOIC
8-Lead CERDIP
θ
JA
155
140
θ
JC
33
15
Unit
°C/W
°C/W
ESD CAUTION
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
[align=center][/align] [size=4]Now Firefox is really rubbish, it opens slowly and needs to be upgraded frequently. The interface is not refreshing. [/size] [size=4]I switched to a domestic browser, 36...
How to Improve VRLA Batteries The main purpose of lead-acid battery research and development:——Achieve maximum discharge capacity and deep discharge application;——After multiple charge and discharge c...
PCB engineers need to pay attention to many things. PCB engineers often draw computer motherboards and are very proficient in excellent tools such as Allegro. However, it is a pity that they rarely kn...
After running a program to write flash read protection and write protection, jLink cannot download and debug (this is expected).But when I run the "J-link stm32 unlock" program to remove the protectio...
The electronic design competition is coming again. Xiaoguan went to the EE Download Center to collect some high-quality tutorials on intelligent control from previous years of electronic design compet...
0. Introduction
In daily life, we often see some special-purpose vehicles. When these vehicles pass through intersections, they often obtain the right of way at intersections by temporarily op...[Details]
Product series: PB-B-RS232/485 interface (hereinafter sometimes referred to as "interface") is a product in the PROFIBUS bus bridge series.
The main purpose of the bridge series ...[Details]
As a simple and practical input device, buttons have been used in various microcontroller application systems and are ubiquitous. However, the buttons used in different practical occasions are also...[Details]
12v Lead Acid batteries used in trucks, cars, RVs and uninterruptible power supplies are usually rated at 12V. This circuit monitors the battery, the charge and discharge curves, gives the cu...[Details]
introduction
MEMS is a high-tech that has flourished on the basis of integrated circuit production technology and dedicated micro-electromechanical processing methods. Pressure sensors develop...[Details]
0 Introduction
High-precision current source can provide high-precision current supply for precision instruments, and is suitable for automatic measurement tasks of various resistors in semico...[Details]
The DisplayPort interface standard is approved by the Video Electronics Standards Association (VESA) to provide an open, scalable standard for the entire industry. The development of DisplayPort ca...[Details]
Analysis of the three core aspects of digital TV transmission standards
According to the differences in regionality, transmission method and modulation method, the transmission method needs to...[Details]
introduction
Steam turbines are driven by high-temperature and high-pressure steam generated by boilers to run at high speed. They are key power equipment in thermal power plants. The emergenc...[Details]
As the global LED market demand continues to increase, my country's LED industry will face huge opportunities in the future. However, the core LED technology and patents are basically monopolized b...[Details]
LED is now known as the fourth generation of light sources. High-power LED has many advantages over traditional light sources in outdoor lighting.
1 LED lamps have high light efficiency
C...[Details]
This article focuses on closing the feedback loop of an isolated power supply using a TL431 shunt regulator. The article discusses a method to extend the bandwidth of the power supply control loop ...[Details]
Direct digital frequency synthesis (DDS) has fast frequency switching and modulation capabilities and is widely used. However, when low power consumption and low cost are the main considerations, D...[Details]
1. Introduction
Modern modular machine tools are equipped with a large number of electronic devices to meet the requirements of processing accuracy, processing speed, etc. If the conventional ...[Details]
TMC428 is a stepper motor motion controller from TRINAMIC. It can reduce the workload of motor control software design and development costs. The 3-axis stepper motor drive control system based on ...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
