[i=s]This post was last edited by zhangjsh on 2018-7-15 11:30[/i] [size=4] [/size] [size=4] [size=5] Today we will disassemble an "Emerson EC3-X33 High-efficiency Superheat Controller". EC3-X33 is a h...
I have an XP system and currently have VS2008 installed. But when I install "Windows Embedded CE6.0", it says that VS2005 and Smart Device Programmability for VC++ are not installed. Can't I use VS200...
This frequency meter can measure the frequency parameters of continuous carrier signals (walkie-talkies, cordless phones) and digital signals (GSM, CDMA, PHS, wireless remote controls, etc.), with sig...
This is a 50-second timer. We want to use external interrupts to form a countdown. #include#define GPIO_DIG P0 sbit LSA=P2^2; sbit LSB=P2^3; sbit LSC=P2^4; code unsigned char sag[10]={0x3F,0x06,0x5B,0...
In the past few days, the news that ZTE was "banned" by the US Department of Commerce has triggered widespread reflection and concern in various domestic industries about the lack of independent co...[Details]
"Originally, there are many people who can design very good
chips
, but the market does not give domestic
chips
the opportunity to iterate, and domestic companies cannot give engine...[Details]
CMSIS Driver has similar API functions and similar calling methods. It is a further encapsulation based on the ST HAL library. It is much more convenient and simpler to use and configure than the ST ...[Details]
In the project, CPLD is needed to complete part of the algorithm design. The parameters are given by AVR, so the communication between AVR and CPLD needs to be completed. Therefore, a test program is...[Details]
This paper combines embedded control technology with network control technology to realize the design of temperature control system based on single chip microcomputer through Internet control. Th...[Details]
The implementation of CAN driver under embedded operating system Android requires not only adding CAN driver device in Linux kernel, but also implementing the call of Android HAL layer. Taking S5...[Details]
1. Heart rate measurement principle 1. What is a heart rate module? The heart rate module is professionally used to monitor the heart rate of the wrist, fingers, forehead, earlobe, chest and other ...[Details]
Notes on inverter installation and maintenance:
1. Before installation, you should first check whether the inverter is damaged during transportation.
2. When selecting an installa...[Details]
Independent watchdog (IWDG) and low power mode are often used in STM32 development. The watchdog is to detect and solve faults caused by software errors, and the low power mode is to enter sleep mode...[Details]
A crystal oscillator can be electrically equivalent to a two-terminal network consisting of a capacitor and a resistor in parallel and a capacitor in series. In electrical engineering, this network h...[Details]
This program sets the LED running light and the 0-16 numbers of the 0th position of the digital tube to light up in a cycle. The digital tube program cannot be put into the main function, because the...[Details]
T1 or T2 are two timers/counters of MCS-51 microcontroller. The first method can use two timers/counters to generate rectangular waves. In order to save interface resources, the second method is used...[Details]
Microcontroller MCU
京公网安备 11010802033920号
EEWORLD
