-
UHF and HF are both general technology categories, but each category has independent supporting protocols. HF is more consistent in the 13.56MHz frequency band, although there are many internation...[Details]
-
Designers use PSpice primarily to simulate analog circuits. However, it can also be used to simulate digital filters. The main components in a digital filter are delay elements, adders, and multipl...[Details]
-
Magnetic resonance imaging (MRI) systems for medical and scientific applications require a high-performance, high-power inductor capable of establishing a uniform, strong magnetic field. Transverse el...[Details]
-
The particularity of portable medical devices determines that they should be user-friendly, must work in a sterile environment, and occupy little space and consume low energy.
At the same time, por...[Details]
-
1. Introduction
The intelligent detector discussed in this paper is an integrated semiconductor photodetector. Compared with traditional semiconductor photosensitive devices, its most ...[Details]
-
Most
embedded
systems are powered from a 48V backplane. This voltage is typically stepped down to a lower intermediate bus voltage of 24V, 12V, or 5V to power the circuit board racks withi...[Details]
-
Abstract: This paper introduces the controller, interface, display principle and driving method of the handheld computer LCD display based on the SA1110 microprocessor. Combined with the HPC projec...[Details]
-
Frequent dropped calls, "network busy" messages, and intermittent service are all potential symptoms of poor device interoperability. Often, these issues are caused by either insufficient validatio...[Details]
-
Today, the value of electronic components in cars accounts for 15-20% of the total vehicle. In the future, as more safety electronic devices, fuel consumption and fuel emission control electronic s...[Details]
-
Analysis of automotive sensor testing requirements
At present, the control system used in automobiles can be functionally divided into three parts: sensor unit, control unit and execution ...[Details]
-
Temperature measurement and control are extremely important topics in all aspects of industry, agriculture, scientific research, national defense and people's daily life. Temperature measurement sy...[Details]
-
introduction
Data acquisition is the most basic application field of DSP. The data acquisition system designed in this paper uses the TMS320F2812 DSP chip of TI. The main features of this ...[Details]
-
Abstract: This paper proposes a method of mine environment detection using wireless sensor networks, and gives the network framework, topology and network protocol of wireless sensor networks suit...[Details]
-
nRF9E5 is an intelligent RF chip with an operating frequency of 433/868/915MHz, integrating an 8051 microcontroller, a 4-channel 10-bit A/D converter, and multi-channel RF transceiver.
This ar...[Details]
-
0 Introduction
With the application of computer technology and network technology and the popularization of intelligent buildings, it has become an urgent need to build an intelligent fire...[Details]
PCB Design
京公网安备 11010802033920号
EEWORLD
