TRG22F2DYWLN

When Amazon launched its first cloud computing service, the outside world was not optimistic about this direction, as it had high investment, low profits and many uncertainties. Let's follo...[Details]

This is my first time writing an STM32 program. I have many questions to ask. I want to convert the data of the SO of MAX6675 into the actual temperature and read it out using the serial port tool. I...[Details]

Household photovoltaic power stations mainly utilize idle resources on existing household buildings, such as roofs, wall facades, balconies, courtyards, etc., to install and use distributed photovo...[Details]

Use the STM32 timer input capture module to control 3-way ultrasonic sensors. The  ultrasonic sensor used this time is the common HC-SR04, which is often used in the obstacle avoidance system of smal...[Details]

How to convert the pin voltage value into V using the built-in ADC of STM32? V(ADC) = Value(ADC) * V(ref)/4096 (The ADC of STM32 is 12 bits, so the maximum value of the AD word is 4096) Where V(ADC...[Details]

/*-----------------------------------------------   Name: IIC protocol PCF8591 AD/DA conversion   Content: Use DA input, digital tube display output digital quantity, LED display analog voltage size ...[Details]

Program ideas and defects reference: 51 single chip microcomputer (AT89C52) matrix keyboard detection program #include iom16v.h   typedef unsigned char uchar;   typedef unsigned int uint;   #define ...[Details]

The single-chip microcomputer running light program requires all 32 serial ports to be used, and each serial port has eight LEDs.  Question supplement: The 8051 single-chip microcomputer is used, an...[Details]

A simple experimental programming question for the microcontroller: write a 3-byte binary addition subroutine. The program entry is: addend 1: 22H, 21H, 20H three bytes, 22H is the highest bit; adden...[Details]

Assume that the MCS-51 microcontroller uses a 12MHz crystal oscillator, and wants to use a timer to generate a pulse with a duty cycle of about 30% and a period of 60ms at port P1.0. ;==============...[Details]

1. Pin: 0 in 1 out  Set Status  Output status IO register setting          DDR×A certain bit is set to 1, and the corresponding bit IO is set to output;          PORT×A certain position is 1/0, and t...[Details]

　　 After three years of continuous decline in its mobile phone business, ZTE has finally revealed its true feelings to the outside world: the Chinese market is its weak point, and it is planning to f...[Details]

Mobile phone battery charger program made by STC12C2052AD microcontroller #include  stc12c2052ad.h   #include  intrins.h   #define uchar unsigned char  #define uint unsigned int sbit REF   =P1^0; sbi...[Details]

MSP430 MCU 1602 LCD 60-second timing program //************************************************************** // P3BIT5 connects to RS)-- (BIT7 connects to NE)-- (BIT6 connects to RW) //P4 port sends...[Details]

MSP 430 MCU key program #include msp430x14x.h   #include "key.h"  void Init_Port(void)  {      //Set all pins of P1 port to input mode during initialization      P1DIR = 0;        //Set all pins of ...[Details]