or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
www.latticesemi.com
1-1
DS1006
Introduction_01.7
Lattice Semiconductor
Introduction
LatticeECP2/M Family Data Sheet
Table 1-2. LatticeECP2M (Including “S-Series”) Family Selection Guide
Device
LUTs (K)
sysMEM Blocks (18kb)
Embedded Memory (Kbits)
Distributed Memory (Kbits)
sysDSP Blocks
18x18 Multipliers
GPLL+SPLL+DLL
Maximum Available I/O
256-ball fpBGA (17 x 17 mm)
484-ball fpBGA (23 x 23 mm)
672-ball fpBGA (27 x 27 mm)
900-ball fpBGA (31 x 31 mm)
1152-ball fpBGA (35 x 35 mm)
ECP2M20
19
66
1217
41
6
24
2+6+2
304
4 / 140
4 / 304
ECP2M35
34
114
2101
71
8
32
2+6+2
410
4 / 140
4 / 303
4 / 410
4 / 270
8 / 372
8 / 410
16 / 416
16 / 436
16 / 416
16 / 520
ECP2M50
48
225
4147
101
22
88
2+6+2
410
ECP2M70
67
246
4534
145
24
96
2+6+2
436
ECP2M100
95
288
5308
202
42
168
2+6+2
520
Packages and SERDES / I/O Combinations
Introduction
The LatticeECP2/M family of FPGA devices is optimized to deliver high performance features such as advanced
DSP blocks, high speed SERDES (LatticeECP2M family only) and high speed source synchronous interfaces in an
economical FPGA fabric. This combination was achieved through advances in device architecture and the use of
90nm technology.
The LatticeECP2/M FPGA fabric is optimized with high performance and low cost in mind. The LatticeECP2/M
devices include LUT-based logic, distributed and embedded memory, Phase Locked Loops (PLLs), Delay Locked
or product names are trademarks or registered trademarks of their respective holders. The specifications and information herein are subject to change without notice.
[i=s]This post was last edited by cardin6 on 2015-10-16 13:29[/i] I have previously posted a post about DIY 3D printers and I am very happy that many forum members are interested in joining and partic...
I have been troubled by the project debugging and downloading recently. The main reason is that I don’t know why the warning shown in the picture appears when the project is directly debugged:At first...
In a switching power supply, the current after the rectifier bridge is pulsating DC with a wide fluctuation range. Two capacitors are usually used. The large capacitor is used to stabilize the output....
[i=s] This post was last edited by dontium on 2015-1-23 12:51 [/i] Where can I find TI's DDS (Direct Digital Synthesizer) chip? I want to choose a TI DDS, but I don't know which website to choose from...
Entering the information age after the millennium, the huge demand for semiconductor chips has made China the world's largest semiconductor market. According to relevant data, the scale of my count...[Details]
In our common sense, the word technology often has two definitions. The first is the technology sealed in the laboratory. They are like flowers on the mountain top. Only a few people on the mountai...[Details]
On April 20, Alibaba Group announced that it would acquire
the
chip
company Zhongtian Microelectronics and invest in six
chip
companies. Yesterday, JD.com CEO Liu Qiangdong said in a...[Details]
For 80,000
ZTE
(000063.SZ) employees and more Chinese ICT (information and communication technology) industry practitioners, the news from across the ocean on the evening of April 16 kept t...[Details]
1. Purpose In actual product release, if the program stored in the MCU Flash is not protected, some illegal companies may read the program in the Flash through an emulator (J-Link, ST-Link, e...[Details]
In the actual project development process, we often need to get the running time of a section of code. The usual method is to use an oscilloscope to measure it. This blog post will use SysTick to acc...[Details]
I have read the source code of mbed these days, and the interface encapsulation for upper-level application calls is quite good. The code quality is relatively high, the comments are also very detai...[Details]
Using Systick timer to achieve delay 1. SysTick timer characteristics The SysTick timer is a 24-bit down counter, that is, when vlue is decremented to 0, an interrupt is triggered and the load va...[Details]
When Amazon launched its first
cloud computing
service, the outside world was not optimistic about this direction, as it had high investment, low profits and many uncertainties. Let's follo...[Details]
This is my first time writing an STM32 program. I have many questions to ask. I want to convert the data of the SO of MAX6675 into the actual temperature and read it out using the serial port tool. I...[Details]
Since the first draft of the 5G
NR standard was officially launched at
the end of 2017
, the
5G
commercialization process has taken a substantial step forward. From that moment on, mo...[Details]
In the development of artificial intelligence, talent reserve is undoubtedly an important part. Artificial intelligence should be a bottom-level technology that can be deeply embedded in any indust...[Details]
On April 18-19, 2018, at the "Second Distributed Photovoltaic Carnival" held in Hangzhou, Jinko Power and China New Energy Assets Investment, Financing and Trading Platform (hereinafter referred to as...[Details]
A few days ago, Hanergy Chairman Li held a grand launch of Hanwa new products, which once again attracted the attention of the mass media to the development of photovoltaics. The unique Hanergy has gr...[Details]
DIY/Open Source Hardware
京公网安备 11010802033920号
EEWORLD
