-
Today's security industry has entered the era of massive networking. Many enterprises, especially financial institutions, have established multi-level video surveillance networking platforms. Lever...[Details]
-
The automotive industry in 2025 is undergoing a thorough intelligent reshuffle.
Geely wants to make changes in the field of AI cockpits: in the future, there will be no traditional smart...[Details]
-
Keysight Technologies is combining its electromagnetic simulator with Synopsys' AI-driven RF design migration flow to create an integrated design flow for migrating from TSMC's N6RF+ process techno...[Details]
-
Plessey Semiconductors has been acquired by Haylo Labs, which was established in March last year with a $100 million, five-year loan from Chinese technology company Goertek.
Haylo Labs w...[Details]
-
Introduction: In digital circuit calculations, there is no concept of decimal points. You know where the decimal is, but the circuit does not know where the decimal point is. Therefore, you need to...[Details]
-
Generally not, but there are exceptions. For example, a torque motor controller with three-phase output voltage imbalance can cause current imbalance, similar to a phase loss. However, only two pha...[Details]
-
1. Static Balance
Static balancing is performed on one correction surface of the rotor. The remaining unbalance after correction is used to ensure that the rotor is within the specified range ...[Details]
-
Mr. Wang, a BYD owner, recently experienced a "5-minute charge" at a highway service area, boasting a 400-kilometer range. He marveled at the rapid evolution of new energy technol...[Details]
-
STM8S compilation error unable to allocate space for sections/blocks with a total # Welcome to use Markdown editor
I've encountered many strange issues while developing with IAR for STM8, all ...[Details]
-
Sometimes an IAR project is closed abnormally. When you open the IAR project again, the project will not be displayed in the Workspace column, as shown in the following figure:
C...[Details]
-
Why does the xenon lamp not light up?
There are many reasons why a xenon lamp might not light up. Poor contact, a damaged component, or a blown bulb are all possible reasons. This requires a l...[Details]
-
What is the difference in response time when the output uses cyclic refresh and direct refresh?
The time required from when the PLC receives an input signal to when the PLC outputs a con...[Details]
-
Recently, Unitree released its new quadruped robot dog, the Unitree A2. The device weighs approximately 37 kg and has an empty-load range of 20 km. According to company disclosures, the product is ...[Details]
-
1. One-way starting control circuit
1. Circuit operation analysis
1) Close the power switch QS and press the start button SB2. The contactor coil KM is energized, the normally open ...[Details]
-
Recently, a friend asked in the background: the recently released Yangwang U8L uses the RoboSense M1P, a long-range LiDAR, for its lateral LiDAR, while the Zunjie Wenjie series uses a TOF solid-sta...[Details]