All specifications are typical at nominal input, full load at 25 °C unless otherwise stated.
EMC Charateristics
Conducted emissions:
Radiated emissions:
ESD air:
ESD contact:
Surge:
Fast transients:
Radiated immunity:
Conducted immunity:
EN55022, FCC part 15
EN55022, FCC part 15
EN61000-4-2, level 3
EN61000-4-2, level 4
EN61000-4-2, level 3
EN61000-4-4, level 3
EN61000-4-3, level 3
EN61000-4-6, level 3
120 Vac, 60 Hz
120 Vac, 65 W
Input/output
Input/chassis
Fixed
283 g (10 oz)
MIL-HDBK-217F
150,000 hours
Level A
Level A
Perf. criteria 1
Perf. criteria 1
Perf. criteria 1
Perf. criteria 1
Perf. criteria 2
Perf. criteria 2
16 ms @ 65 W
72% typical
4000 Vac
1500 Vac
100 kHz, ± 5 kHz
Rev.11.2.09_104
NLP65 Medical
2 of 4
General Specifications
Hold-up time:
Efficiency:
Isolation voltage:
Switching frequency:
Approvals and standards:
Weight:
MTBF demonstrated:
EN60601, UL2601, CSA 22.2 No. 125
Environmental Specifications
Thermal performance:
Operating ambient
(See derating curve)
Non-operating
0 °C to 50 °C, ambient,
convection cooled
50 °C - 70 °C ambient,
convection cooled
Peak (0 °C to 50 °C, 60 s)
Relative humidity:
Altitude:
Vibration (See Note 5):
Shock
Non-condensing
Operating
Non-operating
5 - 500 Hz
per MIL-STD-810E
0° C to +70 °C
-40 °C to +85 °C
65 W
Derate to 50% load
See table
5 to 95% RH
10,000 feet max.
30,000 feet max.
2.4 G rms approx.
516.4 Part IV
0°C
10°C 20°C 30°C 40°C 50°C 60°C 70°C
NATURAL
CONVECTION
COOLING
38W
32W
75W
20 CFM FORCED AIR COOLING
65W
DERATING CURVE
Output Power (Watts)
Embedded Power for
Business-Critical Continuity
Ordering Information
Output
Voltage
+5 V
+12 V
–12 V
+5 V
+24 V
+5 V
+12 V
+12 V
+15 V
+24 V
Output Current
Max
(1)
7A
2.5 A
0.5 A
7A
2A
7A
2.5 A
5.4 A
4.4 A
2.7 A
Peak
9.1 A
3.3 A
0.81 A
9.1 A
2.6 A
9.1 A
3.3 A
7A
5.7 A
3.5 A
Fan
(10)
8A
3A
1A
8A
2A
8A
3A
6.5 A
5.3 A
3.5 A
Ripple
(4)
50 mV
150 mV
120 mV
50 mV
240 mV
50 mV
150 mV
120 mV
150 mV
240 mV
Total
Regulation
(6)
±2.0%
±5.0%
±5.0%
±2.0%
±5.0%
±2.0%
±5.0%
±2.0%
±2.0%
±2.0%
NLP65-9912J
NLP65-9915J
NLP65-9924J
NLP65-9929J
NLP65-9920J
Model Number
(11, 12)
NLP65-9908J
Rev.11.2.09_104
NLP65 Medical
3 of 4
Notes
Natural convection cooling. Models NLP65-9929J, and NLP65-9908Jmust not exceed 62.5 Watts continuous output power with natural convection. Model
NLP65-9920J not to exceed 65 Watts continuous output power with natural convection.
2
When the input voltage is less than 90 Vac the operating temperature range is 0
°
C to +40
°
C. The ripple and regulation specifications may not be met.
3
Peak output current lasting less than 60 seconds with duty cycle less than 5%. During peak loading, output voltage may exceed total regulation limits.
4
Figure is peak-to-peak for convection power rating. Output noise measurements are made across a 20 MHz bandwidth using a 6 inch twisted pair, terminated
with a 10 µF electrolytic capacitor and a 0.1 µF ceramic capacitor.
5
Three orthogonal axes, random vibration 10 minutes for each axes, 2.4 G rms 5 Hz to 500 Hz.
6
To maintain stated regulation then:
for single output units
I ≥ 0.2 A I max.
for multiple output units
0.25 ≤ I(A)/I(B) ≤ 5, for I(A) ≥ 0.2 A I(A) max.
7
For optimum reliability, no part of the heatsink should exceed 120
o
C, and no semiconductor case temperature should exceed 130
o
C.
8
CAUTION: Allow a minimum of 1 second after disconnecting line power when making thermal measurements.
9
This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product.
10
Maximum continuous output power for all multiple output models must not exceed 75 Watts with 20 CFM forced air cooling at 50
o
C.
11
The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant.
12
NOTICE: Some models do not support all options. Please contact your local Emerson Network Power representative or use the on-line model number search
tool at http://www.PowerConversion.com to find a suitable alternative.
1
Embedded Power for
Business-Critical Continuity
Americas
5810 Van Allen Way
Carlsbad, CA 92008
USA
Telephone: +1 760 930 4600
Facsimile: +1 760 930 0698
Rev.11.2.09_104
NLP65 Medical
4 of 4
5.00
(127.00)
4.550
(115.57)
J1
3 N
1 L
3.00
(76.20)
J2
C19
6
T1
2.550
(64.770)
0.225
(5.715)
Europe (UK)
J3
1
Waterfront Business Park
Merry Hill, Dudley
West Midlands, DY5 1LX
United Kingdom
Telephone: +44 (0) 1384 842 211
Facsimile: +44 (0) 1384 843 355
Asia (HK)
14/F, Lu Plaza
2 Wing Yip Street
Kwun Tong, Kowloon
Hong Kong
Telephone: +852 2176 3333
Facsimile: +852 2176 3888
For global contact, visit:
Mounting
Hole Diameter
0.156 (4.00)
ALL DIMENSIONS IN INCHES (mm)
MAXIMUM COMPONENT
HEIGHT 1.26 (32.00)
TOLERANCE: .xxx
0.005"
.xx
0.02"
www.PowerConversion.com
techsupport.embeddedpower@
emerson.com
While every precaution has been taken to ensure
accuracy and completeness in this literature, Emerson
Network Power assumes no responsibility, and disclaims
all liability for damages resulting from use of this
[align=left][color=rgb(62, 62, 62)]Supercapacitor, also known as double-layer capacitor, golden capacitor, farad capacitor. The biggest difference between it and ordinary capacitor is that it is an el...
Hello, everyone. I don't know much about CD burners, but I have some questions about some of their working principles and controls (as a newbie, I feel that optical carving and burning are similar). I...
A spectrum analyzer is used to measure the amplitude and frequency relationship of an input signal over the entire frequency range of the instrument....
The necessity and feasibility of computer simulation of programmable controller (PLC) control of general mechanical presses are discussed, and the corresponding simulation software is developed . The ...
I have been studying the segment LCD driver for a while. I just finished it today. I was always struggling with it before. I used PSoC Creator to create the original part, and then called LCD_Seg_Star...
MSP430 MCU BasicsThe CPU of the MSP430 MCU belongs to a RISC (Reduced Instruction Set) processor. The RISC processor is basically designed for high-level languages, because the reduced instruction sys...
Recently, the " ZTE
incident"
caused by the Sino-US trade war
has caused heated discussions in the electronics industry. It not only reflects that Chinese companies are lagging behind in the...[Details]
When the domestic discussion about "ZTE being banned" was hot, Alibaba officially announced the acquisition of chip supplier
Zhongtianwei
, but the investment amount was not disclosed. At t...[Details]
When Amazon launched its first
cloud computing
service, the outside world was not optimistic about this direction, as it had high investment, low profits and many uncertainties. Let's follo...[Details]
In Windows environment, the source code is encoded in UTF-8. If the source file created by STM32CubeMX contains Chinese comments, then using STM32CubeMX to regenerate the source code will cause the C...[Details]
This is my first time writing an STM32 program. I have many questions to ask. I want to convert the data of the SO of MAX6675 into the actual temperature and read it out using the serial port tool. I...[Details]
At the beginning of the new year of 2018, after the release of the national photovoltaic policy, we found that the state’s support for village-level poverty alleviation power stations has not weake...[Details]
WPG Holdings announced that its subsidiary Youshang has launched a wireless smoke alarm solution based on STM and Semtech . With the development of the national economy and the enhancement of...[Details]
The STM32 watchdog has two WWDG and IWDG. The biggest difference between the two is that IWDG has only one lower limit for feeding, while WWDG, as the name implies, must be fed within a range to ensu...[Details]
How to convert the pin voltage value into V using the built-in ADC of STM32? V(ADC) = Value(ADC) * V(ref)/4096 (The ADC of STM32 is 12 bits, so the maximum value of the AD word is 4096)
Where V(ADC...[Details]
The single-chip microcomputer running light program requires all 32 serial ports to be used, and each serial port has eight LEDs. Question supplement: The 8051 single-chip microcomputer is used, an...[Details]
A simple experimental programming question for the microcontroller: write a 3-byte binary addition subroutine. The program entry is: addend 1: 22H, 21H, 20H three bytes, 22H is the highest bit; adden...[Details]
LiDAR is a comprehensive light detection and measurement system. Compared with ordinary radar, LiDAR can provide high-resolution radiation intensity geometric images, distance images, and speed im...[Details]
1. Pin: 0 in 1 out Set Status Output status IO register setting DDR×A certain bit is set to 1, and the corresponding bit IO is set to output; PORT×A certain position is 1/0, and t...[Details]
1. ATMEGA128 Data Sheet Watchdog Timer The watchdog timer is driven by an independent 1 MHz on-chip oscillator. This is a typical value at VCC = 5V. See the characteristic data for typical val...[Details]