There is a GPS on the left side of the board and a GPRS on the right side. It is a bit difficult, so I have to pick the soft persimmon. Let's get the clock chip PCF8563 first.First, use stm32cube to c...
Author: TI engineer Sunny Qin Due to its high resolution and sampling rate, SAR ADC has been favored by many industrial and automotive customers. However, due to its special characteristics, SAR ADC a...
[font=微软雅黑][size=3][color=#2f4f4f]The thing is, as shown in the picture below, a colleague told me that he has a Garmin vivosmart bracelet, and there is a problem with the screen display. He contacted...
[b]1 [/b][b]Preface[/b] The emergence of GPRS (General Packet Radio Service) makes full use of the existing GSM network. It is not only suitable for intermittent, sudden or frequent, small data transm...
In terms of image processing, I used to use opencv and MATLAB more. I didn't have much experience with single-chip microcomputer processing. I gained a lot from this competition. The tracking video sh...
I am using Freescale MC9S12DG128B. I have made a PH0 interrupt program, but I cannot enter the interrupt. Please give me some advice. The program is as follows: #include hidef.h /* common defines and ...
introduction
1 The significance of using RTOS on MSP430
It is understandable that it is meaningless to use RTOS on MSP430. Because the hardware resources of MSP430 are limited (for exampl...[Details]
Microchip's PIC18F46J50 is a low-power, high-performance 8-bit USB microcontroller (MCU) using nanoWatt XLP technology. The current in deep sleep mode can be as low as 13nA, the operating voltage i...[Details]
In
circuit design,
current
measurement
is widely used, and the main fields are divided into three categories: in measurement,
the electric meter
is used to measure the curre...[Details]
Analog engineers have traditionally struggled with complexity when designing power supplies that required multiple outputs, dynamic load sharing, hot-swap, or extensive fault-handling capabilities....[Details]
The reason for the light decay of white LEDs: the decline of phosphor performance
So far, the rapid decline of the luminous performance of white light LEDs, especially low-power white light LE...[Details]
Two simple circuits are implemented to drive two LEDs from a battery powered microprocessor.
This design is based on a circuit that uses three resistors and a microprocessor I/O pin as an input h...[Details]
1 Introduction
As an emerging microfabrication technology, micro-electromechanical system (MEMS) technology has begun to be applied in various fields. It can integrate functions such as inform...[Details]
Microcalorimetry
is used to determine energy relationships. Microcalorimetry techniques are often required when performing calorimetric experiments with small sample sizes or slow heating rat...[Details]
Flooded Batteries
This battery developed in Germany can be used to power flashlights, strobe lights and toys as long as it is filled with water. This battery can be stored for 50 years and can...[Details]
Nippon Electric Works and Volvo Technology Japan have developed a wireless power supply system for electric vehicles (EVs). Using this system, the two companies have successfully conducted an exper...[Details]
Introduction
Liquid crystal, as a display device, is widely used in low-power products such as instruments, meters, and electronic equipment with its unique advantages. In the past, the displ...[Details]
This article will introduce a design method for a distributed control system used in a tracking car, which can perform distributed control of motor modules, sensor modules, and lighting control mod...[Details]
Introduction
Nowadays, people pay more and more attention to the security alarm system, and people have higher and higher requirements for the functions and performance of the alarm. This paper prop...[Details]
0 Introduction
Wireless Sensor Network (WSN) monitors the target by deploying a large number of sensor nodes in the target area. WSN realizes the positioning and tracking of the target, determi...[Details]
1 Introduction
With the rapid economic development, my country's electricity demand has been growing at a rate of more than 20% per year. According to the current economic development trend an...[Details]