Everything else is normal. ADS compilation can pass, AXD can also simulate. The program is cut according to a tested normal program. The problem is: for example, second=20 is displayed at point (x,y)....
I'm in urgent need of the source code for wireless transmission with dual-channel ADC based on STM32F103C8BT. I have the program for wireless NRF to USB communication and the program for ADC, but I la...
I would like to ask you: How can the computer output signal (deviation) drive the electric cross slide to move? I don't understand what specific principle is needed. What equipment and devices are nee...
I downloaded 3.3, but it doesn't work. When I save and launch it, I get this error: Error automatically generating board date file.:The board config file 'extra' has errors in its syntax. Thank you....
Has anyone made a 2wire bus? It is similar to the one used by fire detectors, using 2 wires, not distinguishing directions, which can be used for power supply and bidirectional transmission of small a...
introduction
my country has a vast territory and a large population. The scale of housing construction is huge, and the amount of residential construction is large and wide. It is still on t...[Details]
In the previous series, we have listed some basic knowledge of C language in Tables 1 to 3. We hope that beginners can strengthen their memory of the above tables and gradually learn to use them wh...[Details]
1 Introduction
Intelligent control instruments are one of the most commonly used controllers in industrial control. They are mainly aimed at a specific parameter (such as pressure, tempera...[Details]
With the widespread application of new services and technologies in the communications industry, the scale and capacity of operators' network construction are getting larger and larger, and the ris...[Details]
Distributed Wireless Communication System (DWCS) uses distributed antennas, distributed processing control, joint signal processing and other technologies to improve the system's spectrum efficie...[Details]
For battery-powered portable devices, in addition to breaking through the limitations of processing power, the performance of portable system power supplies also needs to be continuously improved. ...[Details]
The most important components of new energy electric vehicles are power batteries, electric motors and energy conversion control systems. The power battery must achieve high performance such as fas...[Details]
introduction
Temperature and humidity are the main environmental parameters of industrial and agricultural production. It is of great significance to measure them accurately and timely. Using a s...[Details]
1 Introduction
The stepper motor is an actuator of an open-loop servo motion system, which is controlled in a pulse mode and outputs angular displacement. Compared with AC servo motors and DC servo ...[Details]
High specific energy lithium/thionyl chloride (Li/SOCl2) batteries are widely used in multi-functional intelligent meters (such as smart meters, water meters, etc.) as real-time clocks and memory b...[Details]
The situation of "excessive neutral current" mentioned here means that when the three-phase load is balanced, the neutral current is still too large, and the neutral current is more than 1.5 times ...[Details]
3. Driving circuit design
The power driver uses a field effect tube, which is a field-controlled device with a capacitance effect between the gate and source, so it has high requirements for t...[Details]
The Challenge:
Created to monitor the pulp production process in large paper mills to save energy and reduce costs.
The Solution:
To increase throughput, save energy, and op...[Details]
The physical interference of dc/dc switching power converters is well known unless the system and circuit diagram are carefully designed. These converters can inject unwanted charge into the electr...[Details]
This article examines some of the requirements that need to be met when designing DC/DC converters used in telecom and distributed power systems (DPS). Telecom DC/DC converters have an input voltag...[Details]