Q16PP2GKKSB02E

Dong Yang, executive vice president of the China Association of Automobile Manufacturers, said on the 26th that according to the authorization of the Ministry of Industry and Information Technology...[Details]

1. Photovoltaic inverter installation process 1. Preparation before installation Are the product accessories, installation tools and parts complete? Is the installation environmen...[Details]

UART has three operation modes: polling mode, interrupt mode and DMA mode. Chip: STM32F103C8T6 Application Pin: Output: PA0, PA1 USART1 Configuration interface Add interrupt configuration Add DMA...[Details]

0. Preparation First use st-link to connect the stm32 core board and PC for burning St-link Stm32 3.3V 3.3V GND GND SWDIO PART SWCLK DCLK Then connect with USB serial port board to v...[Details]

Recently, the "Smart Photovoltaic Industry Development Action Plan (2018-2020)" jointly issued by six departments has put this concept on the forefront. Photovoltaic smart solutions will become the ne...[Details]

China Energy Storage Network: At the Boao Forum, Zhu Min, the current dean of the National Institute of Finance at Tsinghua University, said: "When talking about blockchain, we must first sep...[Details]

    With the development of information technology, intelligence, informatization and networking have become the development trend of modern industrial control. Since the 1980s, the rapid development...[Details]

Using the WWDG of STM32F030, it is found that the MCU will not be reset under STOP, just like the sleep mode of STM8S. Paste the watchdog code: /******************************************************...[Details]

The key is the configuration of registers. The T1 timer (16 bits) of CC2530 needs to configure three registers: T1CTL, T1STAT, IRCON Here is just a brief introduction. For more details, please refer ...[Details]

The frequency calculation formula of the PWM wave generated by the output comparison mode of the timer is: 72M/((2*(arr+1))*(psc+1) ) For example, if you set: PWM_Init(1000-1,72-1); (PWM_Init(arr,psc...[Details]

MCS-51 single-chip microcomputer timer/counter experiment programming program Programming requirements: 1. Connect a light-emitting diode LED to the P1.0 pin, light up for two seconds, turn off for o...[Details]

Use P1.0 to output 1KHz and 500Hz audio signals to drive the speaker as an alarm signal. It is required that the 1KHz signal sound for 100ms and the 500Hz signal sound for 200ms, alternating between...[Details]

Code: void TEST(volatile near unsigned char* IO,unsigned char n,BOOL value) { unsigned char  a; unsigned char  b; a=*IO; b=0x01; b=b n; if(value) { *IO=a | b; } else { b=~b; *IO=a & b; } } PIC stru...[Details]

#include iom16v.h   #include macros.h #include "key.h" #include "1602.h" #include "delay.h" unsigned char display ={0,0,0}; //display data void main(void) {  unsigned char Key;    LCD_init();  ...[Details]

　　According to the design requirements, the maximum voltage gain ≥ 60dB is achieved within a wide signal bandwidth (0-10MHz), and the ability to continuously adjust the gain or preset the gain in 5dB...[Details]