EEWORLDEEWORLDEEWORLD

Part Number

Search

PH1-SS2LC372N

Description
Transponder, LC/SPC Connector,
CategoryWireless rf/communication    Optical fiber   
File Size240KB,6 Pages
ManufacturerJDS Uniphase Corporation ( VIAVI )
Websitehttp://www.jdsu.com/index.html
Download Datasheet Parametric View All

PH1-SS2LC372N Overview

Transponder, LC/SPC Connector,

PH1-SS2LC372N Parametric

Parameter NameAttribute value
MakerJDS Uniphase Corporation ( VIAVI )
Reach Compliance Codeunknown
Other featuresIT ALSO OPERATE FROM 1280NM TO 1600NM
body height13.2 mm
Body length or diameter84.1 mm
Communication standardsGR-253, OC-192, SONET
Connection TypeLC/SPC CONNECTOR
Fiber optic equipment typesTRANSCEIVER, TRANSPONDER
Nominal operating wavelength1551 nm
Nominal optical power output0.562 mW
minimum return loss-27 dB
COMMUNICATIONS MODULES & SUBSYSTEMS
10 Gb/s TDM/DWDM 300 Pin SFF MSA SR2/IR2/LR2 Transponder
PH1 Series
Key Features
• Three configurations supporting SR2/IR2/LR2 applications
• Supports dense wavelength division multiplexing
(DWDM) applications (without wavelocker)
• Microprocessor controls to support I2C
• Integrated 16:1/1:16 mux/demux
• Small form factor package (2.2" x 3.0" x 0.53") for high
density applications
• Low power consumption: 4.8 W typical, 6.8 W maximum
for TDM applications
• 70 °C maximum operating temperature
• High sensitivity PIN or APD receivers
• SONET, FEC, Ethernet and Multirate Capable Versions
• Forward, counter and line timing clocking modes
Applications
Telecommunications
Metropolitan Area Networks
Subscriber loop
Intra-office SONET/SDH
High bit-rate data communications
JDSU 10 Gb/s PH1 Series transponders are intended for 1550 nm system
applications with reaches of up to 80 km. The series includes three different
transponders for SR2 (25 km), IR2 (40 km), and LR2 (80 km) TDM or DWDM
applications. Each transponder accepts 16 bits of parallel digital data and converts
it to a 10 Gb/s NRZ modulated optical signal. It also accepts a 10 Gb/s NRZ
modulated optical signal and converts it into 16 bit wide parallel digital data.
The PH1 series offers low DC power dissipation and is available in either a small
form factor package (2.2 x 3 x 0.53 inches) or in a larger footprint (3.5 x 4.5 x 0.53
inches) package, depending on system thermal performance requirements. The
transmit design uses an Electro-Absorptive Modulated Laser (EML) which,
depending on the configuration, produces an average output power of between
-4 dBm to 2 dBm (EOL). A PIN (-17 dBm typical sensitivity) or APD (-24 dBm
typical sensitivity) receiver is available, based on system configurations.
JDSU PH1 Series transponders are designed to support the following data rates:
9.953 Gb/s (SONET), 10.3125 Gb/s (Ethernet), 10.664 Gb/s (FEC Encoded),
10.709 Gb/s FEC, or 11.09 Gb/s EFEC. They meet all applicable SONET/SDH standards.
Compliance
• Telcordia GR-253-Core
NORTH AMERICA
:
800 498-JDSU (5378)
WORLDWIDE
:
+800 5378-JDSU
WEBSITE
:
www.jdsu.com
Will the push-pull circuit be straight through?
The step-down circuit shown in the figure In normal operation, if there is a sudden power failure, that is, all three power supplies are gone, and then the power is turned on again When the op amp U1 ...
shaorc Analog electronics
Research on airborne SAR motion compensation sensor
A motion sensor solution that does not rely on airborne main inertial navigation is proposed, which is a combined motion information system based on GNSS/SINS. That is, during SAR imaging, pure inerti...
frozenviolet Test/Measurement
Shenzhen to build automotive electronics base with output value of RMB 40 billion in 2010
In 2005, the sales of Shenzhen's automotive electronics industry reached 16 billion yuan, and five years later, this figure will double due to the promotion of the automotive electronics industry clus...
frozenviolet Automotive Electronics
(Arm ads1.2) Why does such a simple compilation also fail?
;Init.s Import Main Area Init,Code,ReadOnly ... armasm Init.s always says that unrecognized opcode is found, that is, import, area is an unrecognized opcode? Is there something I need to set in ads1.2...
lingilngmj ARM Technology
[Help] I/O port input and output problem (urgent)!!!
Dear experts: If I have an I/O port that needs to write data and read data, do I need to frequently switch the input and output direction of this I/O port? For example, before reading data from the I/...
hbxgyjs Microcontroller MCU
Award-winning live broadcast: Third-generation TI C2000 new features resource update
Click to register Live broadcast time March 24, 10:00-11:30amLive Topic Third Generation TI C2000 New Features Resource UpdateLive content Compared with the second-generation C2000, the third-generati...
EEWORLD社区 Integrated technical exchanges

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Robot
development
community

Index Files: 163  2560  1960  608  1716  4  52  40  13  35 
Datasheet   0 1 2 3 4 5 6 7 8 9 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
Room 1530, 15th Floor, Building B, No. 18 Zhongguancun Street, Haidian District, Beijing Telephone: (010) 82350740 Postal Code: 100190
Copyright © 2005-2026 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号