I just used TI's DMA ADC acquisition routine and found that it cannot be used and cannot enter the DMA interrupt, so no data can be acquired. Is there any solution? The code is as follows: [list=1] [*...
Review the past to learn new things, welcome everyone to watch"ADI Power Supply Master Training Course" Beginner Edition [Course Replay]Highlights:
● Power system composition and basic principles and ...
Preparation ubuntu image iso Unetbooti: linux writing tool BOOTICE boot setting tool USB disk a first step, use unetbootin to write the Linux system ISO image to the USB disk.[size=5][size=3][b]"Used ...
I am a newbie, a very newbie. When I used protues to simulate a microcontroller, I changed AT89C51 to AT89C52. There was no problem at first and it could be simulated, but after the change, it could n...
I only have a lanuchpad now and a broken 51 microcontroller.
Since lanuchpad comes with an emulator, I want to continue using lanuchpad as an emulator.
What kind of msp430 microcontroller should I buy...
I am using Microblaze. The program written in EDK can run normally when downloaded to the board. However, when adding microblaze as an IP core of a large ISE project, the program in microblaze does no...
No matter which processor you are learning, the first thing you need to understand is the registers and working mode of the processor.
ARM has 37 registers, including 31 general registers and ...[Details]
In public places such as schools, government agencies, factories and mines, as well as public corridors in residential areas, the phenomenon of long-burning lights is very common, which causes a h...[Details]
A multi-point temperature control heating control system was designed using the SST89E564RC single-chip microcomputer and a new temperature measuring device. The heating system can be controlled in...[Details]
Instrument stepper motor
The stepper motor is an open-loop control element that converts electrical pulse signals into angular displacement or linear displacement. In the case of non...[Details]
1 Introduction
Intelligent control instruments are one of the most commonly used controllers in industrial control. They are mainly aimed at a specific parameter (such as pressure, tempera...[Details]
my country is a big country in agriculture, grain production and consumption. Grains are a necessary condition for our nation to survive and develop. The flour processing industry will exist forever w...[Details]
This paper designs a 16x16LED Chinese character display bar based on single-chip dynamic scanning control, briefly analyzes the principle of Chinese character display, and studies how the LED displ...[Details]
With the widespread application of new services and technologies in the communications industry, the scale and capacity of operators' network construction are getting larger and larger, and the ris...[Details]
Since the late 1990s, with the demand for higher system efficiency and lower power consumption, the technological update of telecommunications and data communication equipment has promoted the deve...[Details]
The DisplayPort interface standard is approved by the Video Electronics Standards Association (VESA) to provide an open, scalable standard for the entire industry. The development of DisplayPort ca...[Details]
introduction
When it comes to the production of mobile phone lithium-ion batteries, the first thing that comes to mind is Japan's industrialized mechanical assembly line, NOKIO, MOTOLROLA's st...[Details]
Rated capacity refers to the maximum output power of the UPS (the product of voltage V and current A).
Usually, the UPS power supplies sold on the market are marked with "W" (watt) for smaller...[Details]
1 Introduction
The stepper motor is an actuator of an open-loop servo motion system, which is controlled in a pulse mode and outputs angular displacement. Compared with AC servo motors and DC servo ...[Details]
Microcontrollers are something that many people want to learn about and are concerned about. In most websites, the hardware requirements are generally as follows:
1. You need a computer, prefer...[Details]
Any power transmission and distribution equipment and power-consuming devices cannot be pure resistive loads, so they must occupy a certain amount of reactive power. The existence of reactive curre...[Details]