The author built a minimum system with STC89C51 as shown below. The power supply uses the chip LM2940 to convert the 8V voltage into 5V and then power the microcontroller, and P2.7 is used to control ...
I did a CAN test on STM32F103VBT6, using TI's VP230 driver. The voltage on pin 230 is correct. The high-speed mode and slope control mode are not working. The program is fine because the same program ...
Because the IO of the microcontroller is 5V, and the sensor signal is 24V, I hope that the sensor can cut off the signal of the optocoupler while the IO controls the optocoupler. Because the IO of the...
Question: When downloading the program using JT-LINK's SW method, what are the requirements for the high and low levels of the BOOT0 and BOOT1 pins?...
[align=center][color=#000][size=15px][size=6][b]8[/b][b]bit[/b][b]7[/b][b]segment digital tube driving experiment[/b][/size][/size][/color][/align][align=center][color=#000][size=15px][flash=500,375]h...
In public places such as schools, government agencies, factories and mines, as well as public corridors in residential areas, the phenomenon of long-burning lights is very common, which causes a h...[Details]
This paper designs a dot matrix LED text display screen that is easy to update, expandable, and low-cost. The way to reduce costs is
① Use the Bluetooth data transmission function of mobile ph...[Details]
PV inverter manufacturer SMA has launched its first DC arc fault circuit interrupter (AFCI) PV inverter and has received UL certification.
The new SunnyBoy AFCI inverter models include 3000-US...[Details]
With the rapid development of intelligent control technology, computers and information technology, the trend of information appliances IA (Information Application), computers and communications integ...[Details]
Spatial Division Multiplexing (SDM) MIMO processing can significantly improve spectrum efficiency and thus greatly increase the capacity of wireless communication systems. Spatial Division Multip...[Details]
LED light sources have many environmental advantages, but early products still have certain technical bottlenecks in heat dissipation and high brightness design that cannot be broken through....[Details]
Since the late 1990s, with the demand for higher system efficiency and lower power consumption, the technological update of telecommunications and data communication equipment has promoted the deve...[Details]
1 Overview
In the field of traditional lighting, the concepts and definitions of lamps and lamps are clear. Lamps and lamps have their own applicable product standards, supporting technical st...[Details]
Rated capacity refers to the maximum output power of the UPS (the product of voltage V and current A).
Usually, the UPS power supplies sold on the market are marked with "W" (watt) for smaller...[Details]
0 Introduction
This paper designs a dot matrix LED text display screen that is easy to update, expandable, and low-cost. The ways to reduce costs are: ① Use the Bluetooth data transmission...[Details]
0 Introduction
In the fields of petroleum, chemical industry, metallurgy, electricity, textile, light industry, water conservancy and other industries and scientific research, relevant pressur...[Details]
Inverter supplier Santerno has been awarded a contract to supply 155MW of sliding inverters to a solar farm in California’s Imperial Valley. The company did not disclose further details about the p...[Details]
The performance of most portable products depends on the quality of the batteries that power them. In recent years, as battery performance has improved, portable products are moving towards smaller...[Details]
With the reform of the education system, the proportion of funds invested in teaching facilities by colleges and universities has become increasingly important. As the most basic hardware condition fo...[Details]
When selecting EMC test equipment, we often encounter the following questions: What is the difference between an EMI receiver and a spectrum analyzer? Why should a receiver be used for EMI testing?...[Details]