In China, Taiwan, Japan: Tel: 1-603-598-0075 • In Korea, Singapore, Australia, India: Tel: 1-203-853-4433 • Fax: 1-203-849-1423
Vectron International reserves the right to make changes to the product(s) and/or information contained herein without notice.
No liability is assumed as a result of their use or application.
No rights under any patent accompany the sale of any such product(s) or information.
www.vectron.com
J-Type Voltage Controlled Crystal Oscillator
Pin Information
Table 1. Pin Function
Pin
Symbol
1
1
2 (5)
3
4
1
5 (2)
6
V
C
N.C.
GND
Output
Tri-State
V
DD
Function
VCXO Control Voltage
No User Connection
Case Ground
VCXO Output
TTL Low to Disable Output. TTL High or Float to Enable Output.
Power Supply Voltage (3.0 V
±10%,
3.3 V
±10%
or 5.0 V
±10%)
6
5
4
TOP VIEW
1
2
3
1. Alternate pin configuration for tri-state control on pin2. Alternate configuration is indicated by the last letter of the code “D” as indicated in table 6.
Performance Characteristics
Table 2. Electrical Performance
Parameter
Supply Voltage
1
Symbol
V
DD
I
DD
Minimum
0.9* V
DD
Typical
V
DD
Maximum
1.1* V
DD
Units
V
mA
V
Supply Current
Output Voltage Levels
Output High
Output Low
Transition times
Rise Time
Fall Time
Duty Cycle
3
4
2
2
10 mA + 0.25 mA/MHz Typical
0.8*V
DD
0.1* V
DD
5.0
5.0
45
183E-6
50
55
155.52
V
OH
V
OL
T
R
T
F
D
f
0
APR
V
C
V
0
I
C
5
V
ns
ns
%
MHz
ppm
V
V
µA
kHz
ppm/V
dBc/Hz
Nominal Output Frequency
Absolute Pull Range
Control Voltage
Center Voltage
See Part Numbering and APR Section
0
V
DD
Please Contact VTI for Details
-1
10
150
Contact VTI for Phase Noise Specifications
1
Leakage Current of Control Input
Control Voltage Bandwidth (-3 dB, V
C
=0.5*V
DD
)
Gain Slope @ V
0
Phase Noise
BW
∆f/∆V
C
φ
N
1. A 0.1
µF
low frequency tantalum bypass capacitor in parallel with a 0.01
µF
high frequency ceramic capacitor is recommended.
2. Figure 1 defines these parameters. Figure 2 illustrates the equivalent 5-gate TTL load and operating conditions under which these parameters are specified and tested.
3. Duty cycle is defined as (on time÷period), with V
S
= 1.4 for TTL or V
S
= 2.5 V for CMOS, per Figure 1.
4. Other frequencies may be available, please contact factory with your special requirements.
5. Wider bandwidth versions are available, please contact VTI for details.
T
V
T
F
R
I
D D
OH
650
Ω
6
2
5
3
V
V
S
V
DD
OL
+
-
.
1
µ
F
. 0 1
µ
F
I
C
V
C
1
4
15pF
1.8k
On Time
0V
Period
+
-
Figure 1. Output Waveform
Figure 2. Output Test Conditions (25±5°C)
±
A J-Type VCXO with an APR of +/-50 ppm will track a +/-50
ppm reference source over all operating conditions. The
same device will typically demonstrate a Total Pull
capability of 150 to 350 ppm.
Absolute Pull Range (APR) is
specified by the fourth character of the product code in Table
6.
Please contact VTI for the APR Application Note.
Absolute Pull Range (APR) Specification
The frequency deviation of the J-Type VCXO is specified in
terms of Absolute Pull Range (APR). APR provides the user
with a guaranteed specification for minimum available
frequency deviation over all operating conditions. Operating
conditions include operating temperature range, power supply
variation, differences in output loading and changes due to
aging.
Oscillator Aging
Quartz stabilized oscillators typically exhibit a small shift in
output frequency during aging. The major factors which lead to
this shift are changes in the mechanical stress on the crystal
and mass-loading of foreign material on the crystal.
[color=#FF0000]I recently ported Samsung's BSP package from April 2009. The first time I downloaded it to NAND FLASH, it started normally. However, when I restarted the system, it crashed. It's the sa...
[font=黑体]Content preview: [/font] Starterware is a non-operating system software development kit based on AM335x launched by TI for industrial customers. It has the characteristics of high real-time p...
[backcolor=rgb(239, 245, 249)]As shown in the figure, I want to collect the voltage value (0-10V) across a resistor. Now I use this module (ad7705). Its chip input is 0-2.5V. It now uses resistor volt...
introduction
With the continuous optimization of surface mount technology (SMT) and the rapid development of chip component manufacturing technology, the application of chip mounters in the el...[Details]
As a wireless broadband metropolitan area network standard, WiMAX technology has greater advantages than previous 3.5GHz MMDS products in terms of non-line-of-sight transmission and spectrum utiliz...[Details]
1. Introduction
Automobile pollution is one of the most important issues that people are most concerned about and need to solve urgently. As an important method for detecting automobile exhau...[Details]
The Mobile Industry Processor Interface (MIPI) Alliance is an organization responsible for promoting the standardization of software and hardware in mobile devices. It has released the D-PHY specif...[Details]
1 Introduction
Ultrasonic waves have strong directivity, slow energy consumption, and can propagate over long distances in a medium, so they are used for distance measurement. Ultrasonic detec...[Details]
VP2188 is a color STN LCD module produced by Jingdian Pengyuan. This module is a dot matrix transmissive color STN display screen with a color scale of 65 k colors and white LED backlight. Its core...[Details]
Continuity test
A variety of devices need to be checked for continuity, including cable assemblies, printed circuit boards, and connectors to ensure that these components have the expected contin...[Details]
OC faults may be the most frequent and the most frequent of all faults in the inverter. They alarm during the startup process, during the shutdown process, during operation, and even when powered o...[Details]
Preface
In recent years, white light LEDs have gradually replaced incandescent bulbs and fluorescent lamps because they have unparalleled advantages over traditional light sources in terms...[Details]
Currently, each country is developing its own USB interface
charging specifications
, which leads to a major problem that a USB interface
charging
device manufactured in one country...[Details]
0 Introduction
With the rapid development of social economy and science and technology, electric locomotives, subways and electric vehicles will be widely used. The power conversion and cont...[Details]
This article discusses the six design steps of LED lighting system design in detail: (1) determine the lighting requirements; (2) determine the design goals and estimate the optics; (3) the efficie...[Details]
Features
POE technology can ensure the safety of existing structured cabling while ensuring the normal operation of the existing network and minimizing costs. The IEEE 802.3af standard is ...[Details]
Based on the actual situation, a remote intelligent anti-theft alarm device for home use, connected to the telephone line, simple to operate, and stable and reliable in operation is designed. When ...[Details]
DSP and ARM Processors
京公网安备 11010802033920号
EEWORLD
